maybe your idle to low, if it continues, I have the fluid injection relay switch replaced.
Yes
Mine did that, it was the fuel pump!
If the torque converter does not unlock, the engine will stall.
Check your idle air control valve
Your idle air controle valve.
An Audi engine typically stalls because it needs maintenance and repair. Sometimes, it is due to a faulty engine or simply because the car is put in a 'stop' position for too long.
often times it either means that the engine is not receiving fuel into the cylinder at the proper timing or that there is not enough fuel coming in to begin with... probably a relatively cheap fix.
No, this will not cause the MIL light to come on, unless you removed one of the sensors such as the MAP sensor. You must have all sensors in place. There is no workaround.
Continue to apply brakes: they're not just power brakes, they also function manually.
You are going to need to stop at the Ford dealer and put it on an engine analyzer for this one.
The stop engine light might not come on on your N14 Cummins when the switch is off.
i had that problem with mine. the problem was an intake vaccuum leak. the engine wasnt getting enough air sucked in at idle and stalling out.