answersLogoWhite

0

The vortec used a plastic timing cover with the crank sensor mounted in it at the lower end. The cover and gasket come as one part and are meant to be replaced when removed. Although I will say that if you clean it properly and dry it well with brake cleaner and use a quality sealer you will be ok reusing it. it is located under the water pump and against the front of the block covering the timing chain, gears and reluctor wheel for the crank sensor.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

Is a 1989 Chevrolet 350 a vortec motor?

I know on my vortec engine the valve cover bolts are in the center of the cover and there is only 4, my racecar has vortec heads and my truck has standard stock heads with four bolts on thew corners


Does a 1997 chevrolet 5.7 vortec 350 have a crank shaft sensor?

YES, It is bolted in the lower passenger side of the timing cover behind the harmonic balancer It is held in place with 1 10mm bolt


Where is the oil pump for the 2003 Chevrolet 2500 hd with a 6.0 vortec motor?

It is on the front of the engine, behind the timing cover where the timing chain and gears are. You will have to remove the front of the engine to get to it.It is not in the oil pan were they use to be. It now slides over the front of the crankshaft.


How do you get the timing chain cover seal out?

The seal on the timing chain cover must be pressed out and the replacement pressed in.


Cam sensor 5.7 vortec?

No cam sensor. Just a crank sensor on the bottom of the timing cover


How can i find timing marks 1998 vortec eng?

I could be wrong, but I have a Vortec 350 in a GMC truck and I think the computer handles the ignition timing. If your talking about valve timing I would assume there are marks on the timing gears like the days of old, but I haven't torn the timing cover off of mine yet.


Does the 2002 Chevrolet Silverado 5.3L engine have a PCV valve?

look om the passengers back side of the valve cover. You need to take off the vortec cover.


Is the v timing mark on v8 vortec timing cover zero?

It is zero at top dead center as long as the #1 piston is all the way up on the compression stroke.


Timing chain replacement on a 390 Ford?

Do I need to pull the oil pan to take off the timing cover on FE 390.


Will a Chevrolet vortec V6 run properly without the cover?

The plastic cover is there soley for looks. The motor should run fine, just aswell without it. It simply covers the intake manifold and injection.


Where is the timing belt on 1987 Chevy Nova?

The 1987 Chevrolet Nova timing belt is located on the front of the engine. You will need to remove the engine cover in order to see the timing belt.


How do you locate timing set wire for 2003 4.3 vortec van?

To locate the timing set wire on a 2003 4.3 Vortec engine, first, ensure the engine is off and cool. Remove the engine cover to access the upper components, then look for the timing cover on the front of the engine. The timing set wire is typically connected to the camshaft position sensor or the ignition control module, so trace the wiring harness from these components to identify the timing wire. Consult a repair manual for specific wiring diagrams to confirm the correct wire location.