0
What else can I help you with?
What is the front wheel bearing torque spec for 1996 grand Cherokee?
It is 175 ft lbs for the front wheel bearing of a grand cherokee
What is the size of the nut that holds the front wheel bearing assembly on a 1997 grand prix?
The size of the nut that holds the front wheel bearing assembly on a 1997 Pontiac Grand Prix is typically a 30mm. It is important to use the correct size socket to avoid rounding the nut during removal or installation. Always refer to the vehicle's service manual for the most accurate specifications.
What is the wheel torque specifications for a 1999 Dodge Grand Caravan?
100 ft lbs
What is the torque specifications for the water pump attaching bolts on a 2005 Jeep Grand Cherokee 5.7L HEMI?
What is the torque specifications for the water pump attaching bolts on a 2009 Jeep Grand Cherokee 5.7L HEMI?
Torque spec for wheel bearing nut 2003 grand prix?
The 2003 Pontiac Grand Prix wheel bearing nut torque specification is 40 pounds. Do not exceed the 40 pound specification or you will risk causing the wheel seal to fail.
How do you change the wheel bearing hub assembly on a 97 Pontiac Grand AM?
Fron or rear?
What is the lug nut torque for a Pontiac grand am?
wheel lug nuts 100 ft lbs according to our Haynes Manual for a 2003 Grand Am page 1-2 under torque specifications
What are the Torque specifications for the exhaust headers on a 2004 Grand Cherokee V8 4.7 SOHC?
The torque specifications for the exhaust headers on a 2004 Grand Cherokee V8 4.7 SOHC typically range from 18 to 22 foot-pounds. It is crucial to consult the specific vehicle's service manual for the precise torque specifications as they can vary depending on the manufacturer and model. Proper torque is essential to ensure a secure seal and prevent exhaust leaks.
Where is a Speed sensors located in a 2001 grand am?
The speed sensor is located inside the Wheel Bearing Assembly, and cannot be replaced separate from the Wheel Bearing Assy.
How do you replace the speed sensor on a 2002 Pontiac Grand Am?
most likely you will have to replace the hub bearing assembly autozone for about $80
What are the head bolt torque specs for a 2002 Pontiac grand prix 3100 v6?
The head bolt torque specifications, for your 2002 Pontiac Grand Prix, is 160 pounds per square inch. The head bolts should be torqued in 40 pound intervals.
Torque specs for a 1996 Pontiac grand am 6 cylider?
For the 1996 Pontiac Grand Am 3.1 liter 6-cylinder, the torque for the intake bolt is 10 ft/lbs. The torque for the rod bearing cap in step one is 15 ft/lbs, and in step two turn an additional 75 degrees.
