answersLogoWhite

0

Two separate flasher relays, one for the signals and one for the hazards. They are both located behind the plastic lower dash panel aprox under the radio. The lower panel must be removed to gain access to the flashers. Be sure to check the fuses and bulbs also.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Why would your hazard lights work but both turn signals do not work on a Chevy s10 pickup?

hazards and turn signals have separate flashers. replace flasher for turn signals


What is the problem if the turn signals work but the hazards do not?

Often, a separate flasher unit is used to activate the hazard flashers. This unit might be bad, or the switch to activate the hazard flashers might be bad. answer always there are 2 flashers.one for turn signals other for hazard replace hazard flasher They have separate fuses also.


Your turn signals do not work but your flashers do on a 1996 Honda accord ex.?

yes


What do you need to replace to make the turn signals and hazard flashers to work in a 1997 Monte Carlo?

Probably turn signal flasher


Ford f 250 Hazard lights work but turn signals do not?

Hazard and turn signals usually use separate flashers, switch the flashers to see if turn signals work and hazards don't, if so replace the flasher you need to replace the blinker flasher unit it is different from the hazard unit they cost about 4 bucks the flasher unit is the big round thing in the fuse panel in the dashboard


Your blinkers wont work but the hazards do in your 94 acura integra it is a fuse?

There are two different flashers on vehicles. 1 for the turn signals, 1 for the hazard flashers.


Turn signals wont work 93 lebaron flasher works for hazard all fuses good but turn signals wont work?

There are two flashers, one for the hazards and one for the signals.


Where are the flashers on a 1996 Toyota Paseo?

On a 1996 Toyota Paseo, the flashers, also known as the turn signal lights, are located at the front and rear of the vehicle. The front flashers are integrated into the headlight assembly, while the rear flashers are part of the tail light assembly. To activate the flashers, you can use the turn signal lever located on the steering column. Additionally, the hazard lights can be activated using the hazard switch, typically found on the dashboard.


Why would the turn signals and hazard flashers on a 2001 Lumina all fail at the same time?

Because the hazard/turn signal relay has failed. A defective/intermittent turn signal switch can also cause this symptom.


2004 Pontiac grand am The turn signals and the hazard flashers both work but when neither one is ingaged the hazard switch unit in dash clicks contiuously Is it the flasher?

yes


1996 Pontiac Sunfire Horn doesn't work can hear relay click and Rear Hazards don't work but turn signals do Why?

Your turn signals and hazards use separate flashers. Your hazard flasher might have bitten the dust. FriPilot sounds like the horn/horns arent working. also sounds like the hazard switch is inop


How do you fix the flashers for the turn signals on a 1996 Mercury Mystique?

: I just changed three fuses in my '97 Mercury Sable... the turn signal fuse, the hazard flasher fuse, and another "autolamp" fuse. None of the three corrected the problem I was having. (turn signals and hazard flashers are not working at all.) I am now trying to replace the electronic flasher, but have not found where to install it. : In any case, the fuses for the turn signals and hazard flashers are not actually very expensive, so you might want to try that first. I bought a variety pack for less than $5. Also, if you look under the cover of the fuse box under your dash, there may be spares so you wouldn't even have to purchase new ones.