0
What else can I help you with?
What color is the reverse wire for a 96 Chevy Tahoe where is it located?
The 1996 Chevy Tahoe reverse wire is light blue. You can find the reverse wire inside of the steering column.
What color are the connector wires on the drivers side sensor on Tahoe?
Wire diagram for 02sensor on 95 Chevrolet tahoe
What are power antenna wiring color codes for 96 Camry?
The red wire is the positive wire. The black wire is the ground wire. The white wire is the auxiliary wire.
What color is the ignition wire on a 2004 Tahoe?
The ignition wire that run to the cap is red. The one that to the key ignition is blue.
How do you get the antenna to go up with a new stereo installed if the antenna wire is connected to the stereo but the antenna won't raise now even from the switch?
The motor that raises and lowers the antenna is controlled by a wire which is connected to the power switch in the stock radio. The wire from the antenna itself has nothing to do with raising and lowering the antenna. Touch the wires that were connected to the stock radio to a hot wire and see if the antenna starts to move. If if does, hook that wire to the wire from the new radio which is supposed to control the antenna motor. If there is no such wire, connect the antenna motor wire to the Accessory circut. The antenna will go up whenever the key is turned on. Or, you can get fancy and install a switch for it.
How to replace antenna on 1992 Toyota pickup?
remove wheel and remove the plastic liner inside the fender. remove the radio and disconnect the antenna wire. Tape another, 10' long wire to the end of the antenna wire. Unscrew the nut around the antenna from on top. pull the antenna and antenna wire out through the fender. Tape the 10' long wire to the new antenna wire and pull it back through the dash to the radio.
How do you get the antenna to go up with a new stereo installed in a 1989 Mercedes 190E 2.6 if the antenna wire is connected to the stereo but the antenna won't raise now even from the switch?
The motor that raises and lowers the antenna is controlled by a wire which is connected to the power switch in the stock radio. The wire from the antenna itself has nothing to do with raising and lowering the antenna. Touch the wires that were connected to the stock radio to a hot wire and see if the antenna starts to move. If if does, hook that wire to the wire from the new radio which is supposed to control the antenna motor. If there is no such wire, connect the antenna motor wire to the Accessory circut. The antenna will go up whenever the key is turned on. Or, you can get fancy and install a switch for it.
What is the purple an whit wire on radio wiring 96 Tahoe?
What is a purple wire on a 96 chevrolet tahoe
Which color wires for a power antenna are 12-Volt?
Typically, the blue wire is used to power the antenna and is connected to the 12-volt accessory wire on the car stereo. Make sure to consult the specific wiring diagram for your car model to confirm.
How do you replace antenna wire on a 2008 Chrysler 300?
To replace the antenna wire on a 2008 Chrysler 300, first, remove the interior trim panel near the antenna base, typically located on the rear deck or roof. Disconnect the old antenna wire from the antenna and the radio unit, then route the new antenna wire through the same path. Reconnect the new wire to the antenna and the radio, ensuring all connections are secure. Finally, replace the trim panel and test the radio to ensure proper reception.
What color is the wire for the antenna rem in a 1998 Nissan Altima?
The color should be the same in all cases because of the E.I.A. (Electronics Industry Association) and it should be Dark Blue.
How does Power antenna needs to come on when the radio is turned on what wire is correct?
Your head unit should have a wire marked as P. Antenna that's the wire you need to connect.
