I assume that you mean, "2.3 liter engine," because 23 liters is pretty big, and Ford never made one that size. The firing order is 1-3-4-2, and cylinder number 1 is the one on the end where the drive belts for the alternator, etc., are; cylinder number 4 is closest to the transmission or output end of the engine. Two and three are, naturally, in order between one and four. Ignition timing is dependent upon a lot of factors, all related to engine/application questions. An initial timing of approximately five degrees before top dead center will get the engine running; you can get better specifications from a shop manual for your particular application. If it is for an automobile in the United States, Europe, Australia, or Japan, there should be a sticker under the hood which gives the tune-up specifications.
A non firing engine can be caused by many things. A bad crank sensor or coil pack are the first two places to check for problems.
To find the number one firing position on a 454 distributor, first ensure the engine is at top dead center (TDC) on the compression stroke for the number one cylinder. You can do this by removing the spark plug for the number one cylinder and rotating the engine until you feel air pressure or see the piston reach its highest point. Once at TDC, the rotor of the distributor should be pointing directly at the terminal for the number one cylinder on the distributor cap. This indicates the position for firing.
first what make and model v12 there are a few
Not Sure What You Are Asking. The Number One Plug Is The First Cylinder On Your Right From Front Of Engine. But Are You Wanting To Know Where Number One Is In The Cap ? The Firing Order Should Be 1-2-3-4-5-6 if you have a 2.8 I`m Pretty Sure Of This. To Actually Find The Position Of The Number One In The Cap You Will Need To Get The Engine On #1 Firing Stroke or TDC. Then Look At Position Of Rotor It Will Be Pointing Toward Position Of Number One. Hope This Helps
123456 left bank first
No. 1 is first, then 3-4-2. #1 is at the front of car.
First, verify the spark plugs are sparking by removing one, grounding it to the engine and verify plug is firing when someone else turns the car over. If you have fire, then check crankshaft position sensor, camshaft position sensor and then fuel filter and fuel pressure.
As viewed from the top of the motor with the c/l of the engine being at 12 o'clock, the first position on the driver side at about 11 o'clock is number one. The others follow around in a clockwise direction as viewed from the top.
The firing order for a 1985 Dodge 360 engine is 1-8-4-3-6-5-7-2. This V8 engine configuration means that cylinder number 1 fires first, followed by cylinder 8, and so on in the specified sequence. This firing order is important for proper engine operation and timing.
The firing order for the 1997 Kia Sephia with a 1.6-liter engine is 1-3-4-2. This means that the first cylinder fires, followed by the third, fourth, and then the second cylinder in that sequence. It's important to ensure correct ignition timing and firing order for optimal engine performance.
The firing order for the Toyota Hilux Y series 1.8 engine is 1-3-4-2. This means that the cylinders fire in the sequence of the first cylinder, followed by the third, fourth, and second cylinders. This firing order helps ensure smooth engine operation and balanced power delivery.
The MODEL A engine firing order is 1,2,4,3, which means that the front cylinder fires first,then the second cylinder,then the fourth cylinder,the last the third cylinder.