0
If you can unbolt the cooler then unbolt it whatever way is easiest. Then remove the radiator. If it is part of the radiator itself then drain the radiator first completely and then disconnect the tranny lines and try to plug them if possible or put then draining into a container. Dont want to mix the fluids. Then remove the radiator. That should be it. That is way that I have done it before.
What else can I help you with?
Can you put an automatic transmission on a 250 straight 6?
The auto transmission will have to have the proper bell housing to line up. The cross member will need to be changed along with the flywheel. you will also need to add a cooler, and possibly change the radiator.
You want to install a transmission cooler on a 2000 gmc sonoma v6 automatic and want to know which trans line is the in and which is the out at the radiator?
Look in the yellow pages under "Transmission Parts". Go to them and buy the proper cooler. They will show you the proper way to install the cooler. Do NOT use an auto parts store. (The top line is from the trans. to the rad., the bottom line is the return. Fluid flows downward in the radiator.)
Where is the transmission outlet fluid line on a E4OD?
The transmission outlet fluid line on an E4OD transmission is typically located on the driver's side, near the rear of the transmission. It connects the transmission to the cooler in the radiator or an external cooler. This line carries fluid away from the transmission to dissipate heat, ensuring proper operation and longevity of the transmission. Always refer to a service manual for precise locations and diagrams specific to your vehicle.
On 94 Dodge Intrepid is there a diagram that shows how to install cooler lines from transmission to radiator?
The cooler lines attach from radiator (on the plastic ends on sides of radiator) facing engine, to the tranny. You may need to use a flared end wrench to loosen them. Install new lines and do not overtighten, you may use an open end wrench to tighten. Properly disopse of old tranny fluid and fill tranny to proper level.
How do you replace radiator on a 2002 Celica?
To replace the radiator on a 2002 Celica, first, ensure the engine is cool and disconnect the negative battery terminal. Drain the coolant by removing the drain plug or lower radiator hose, then disconnect the upper and lower radiator hoses, as well as the transmission cooler lines if applicable. Remove the mounting bolts and lift out the old radiator, then install the new radiator by reversing the removal steps, making sure all connections are secure and refill the coolant. Finally, run the engine to check for leaks and ensure proper operation.
What is proper fan sucking air through radiator to engine or blowing from engine to the radiator?
Actually, both are used. However, it is more common to pull air through the radiator towards the engine. This draws cooler outside air through the radiator. Pushing air from the engine towards the radiator means that you are pulling hot air from around the engine towards the radiator.
Topaz car runs good in cooler weather but when hot out side it runs for about a minite then dies?
Car Runs Good in Cooler wheather but when hot outside it runs for about a miniute then dies.can you please check your car's Cooling system for proper operation, such as radiator fan comes on, rotation of the fan is correct and radiator is not blocked etc?
How hard is it to change transmission fluid in a 88 Chevy Celebrity?
To change the transmission fluid is not particularly difficult. 1. Raise the vehicle as needed and support on stands. 2. Place a suitable drain pan under the transaxle and remove the pan bolts. As you remove the bolts the pan will loosen allowing the fluid to drain out into the drain pan. Be careful to avoid a spill outside the drain pan. 3. While the pan is off is an excellent time to change the transmission filter. 4. Re install the pan. lower the car and refill the transaxle with fresh fluid to the proper level. Alternate way; Remove the pressure hose to the radiator cooler. Start the engine and let the pump drain the fluid into a suitable container. As soon as the flow stops turn the engine off. Reconnect the line and fill the transaxle to the proper level with new fluid.
How to change Ford F250 throw out bearing?
remove the transmission......the proper term is a clutch release bearing
Your computer begins to startup but shuts down before fully booting up?
You need to check that your CPU temperature within the normal. The easiest test is you touch the radiator if it becomes very hot, it means you do not have proper ventilation and the cooler has to be repaired or replaced. Also it's a good practice to replaced the thermal paste between the radiator and CPU. If you have a cooler attached to the chipset (north and south bridges) you need to inspect them too.
How do you know what wrong with 2001 chrysler town and country van when it purges freon after its on and cold in the van?
Check the radiator/condensor fan for proper operation.Check the radiator/condensor fan for proper operation.
Can you substitute transmission fluid for power steering fluid in a 2008 Chrysler sebring?
Automatic transmission fluid is the proper fluid.Automatic transmission fluid is the proper fluid.
