0
What else can I help you with?
How tight does the bolts on a 94 Dodge Intrepid valve cover have to be?
The bolts on a 94 Dodge Intrepid valve cover need to be very tight. You should tighten to 12 N*m or 105 inch pounds.
How do you tighten a valve cover?
There are valve cover bolts around the perimeter of the valve cover. You want these tight but not as tight as you can get them.
How do you change a valve cover gasket on a 2002 Dodge Stratus?
To change the valve cover gasket on a 2002 Dodge Stratus, first ensure the engine is cool and disconnect the negative battery cable. Remove the valve cover bolts and gently lift the valve cover off, taking care not to damage any surrounding components. Clean the surface where the gasket sits, place the new gasket on the valve cover, and reattach it with the bolts, ensuring they are tightened to the manufacturer's specifications. Finally, reconnect the battery and check for any leaks after starting the engine.
How to Replace valve cover gasket 2002 dodge neon?
remove the valve cover pull off the valve cover gasket and put new one up making sure you dont over tighten the valve cover bolts make sure you have correct torque replace all the o rings inside valve cover while changing main gasket for best results
How do you you replace a valve cover gasket on a 1995 Dodge Intrepid?
Begin by removing the valve cover from your 1995 Dodge. Remove the valve cover gasket and clean the surface. Put the new gasket on and return the valve cover to its original position.
How do you change valve cover 1996 Saturn sl2?
First you loosen 11 Bolts with a 10mm socket,after you take out the sparkplug boots,Gently pry up cover with a flat head screwdriver,your done!
Where are the spark plugs on a 1996 dodge stratus?
they are dropped down inside the valve cover. pull the plug wires and use a plug socket and extension to reach them.
Where are the head bolts located prelude?
Your head bolts are located under your valve cover. Take your valve cover off and you will see them. Hope this info. helped.
How do you change valve cover gasket on 2008 aveo?
To change the valve cover gasket on a 2008 Chevrolet Aveo, start by disconnecting the battery and removing any components obstructing access to the valve cover, such as the air intake hose and ignition coils. Next, remove the valve cover bolts using a socket wrench and gently lift the cover off. Clean the mating surfaces thoroughly and place a new gasket in position before reassembling the cover and tightening the bolts to the manufacturer's specifications. Finally, reconnect any components you removed and the battery.
What are the size of bolts for miata valve cover?
4x4
What are the torque specs. for the valve cover bolts on a 1994 dodge spirit V6?
For a 1994 Dodge Spirit with a V6 engine, the torque specification for the valve cover bolts is typically around 89 inch-pounds (or about 10.5 Nm). It's important to tighten the bolts in a crisscross pattern to ensure even pressure. Always refer to a repair manual for your specific vehicle for the most accurate information, as specifications can vary slightly based on the engine type and configuration.
How many bolts on 91 305 caprice are in the vave cover?
There are 4 bolts going through the center of the valve cover.
