0
The torque setting for a Picasso front hub nut is typically around 30 to 35 Nm (Newton-meters). However, it's essential to consult the specific service manual or guidelines for your particular model, as torque specifications can vary slightly depending on the year and design. Always use a calibrated torque wrench to ensure accurate settings and avoid damage to the components.
What else can I help you with?
What is the Torque setting for Daewoo Matiz hub bearings?
front hub 120nm i think
What is the torque setting for the nut that holds the front rotor on a 1999 grand am se?
Actually the nut does not hold the rotor on. Your brake caliper does that. The nut holds the front hub on. correct and the torque setting for the front hub nut is ..284 ft pounds
Chevy Cobalt Torque spec front hub?
chevy cobalt torque specfront hub
Ford Focus front hub nut torque?
If this is the European Ford Focus Front hub nut torque is 300-332Nm.
What is the front hub nut torque setting on a vauxhall vivaro van 2006 plate?
The front hub nut torque setting for a 2006 Vauxhall Vivaro is typically around 250 Nm (184 lb-ft). It's important to ensure that the hub nut is torqued correctly to maintain proper wheel alignment and prevent any issues with the wheel bearings. Always refer to the vehicle's service manual for specific torque specifications and procedures.
2000 Ford Taurus front bearing hub nut torque setting?
Hub and bearing assembly and tighten the bolts to 61-78 ft. lbs. (83-107 Nm)
What are the 1993 Tercel front axle torque setting?
The hub nut is 137 ft lbs......... The two lower bolts and nuts that the strut mounts to wheel assembly is 167ft lbs......... Dont over torque that hub nut you will have problems.......................
What is the torque setting for a fiat ducato front driveshaft hub nut?
The torque setting for a Fiat Ducato front driveshaft hub nut typically ranges between 200 to 250 Nm (Newton-meters). It's essential to consult the specific service manual for your model year, as specifications may vary slightly. Always ensure to use a calibrated torque wrench for accurate measurements during installation.
Torque wrench setting for front hub nut on 04 fiat panda?
The front hub nut on a 2004 Fiat Panda typically requires a torque setting of around 200 Nm (147 lb-ft). It's important to use a torque wrench to ensure the correct specification is met for proper wheel assembly and safety. Always consult the vehicle’s service manual for the most accurate and specific torque settings. Additionally, it's advisable to recheck the torque after a short period of driving.
What is the Front wheel hub nut torque setting for Toyota auris 2007?
The front wheel hub nut torque setting for a 2007 Toyota Auris is typically around 150 Nm (110 lb-ft). It's important to ensure that the nut is tightened to the manufacturer's specifications using a calibrated torque wrench for safety and proper function. Always consult the vehicle's service manual for the most accurate and specific information.
What are the torque specs for 1996 buick lesabre front hub and wheel bearing?
1992 - 1997 Hub Nut Torque is 107 ft-lbs
Front wheel bearing torque setting for 2004 ford focus?
Front wheel bearings are pressed in using a hydraulic press, no torque setting. However, the wheel hub retaining/axle nut that you need to remove and replace in order to change out the bearing needs to be torqued down to 233 ft-lb.
