0
The torque setting for a Fiat Ducato front driveshaft hub nut typically ranges between 200 to 250 Nm (Newton-meters). It's essential to consult the specific service manual for your model year, as specifications may vary slightly. Always ensure to use a calibrated torque wrench for accurate measurements during installation.
What else can I help you with?
What is the torque setting for the nut that holds the front rotor on a 1999 grand am se?
Actually the nut does not hold the rotor on. Your brake caliper does that. The nut holds the front hub on. correct and the torque setting for the front hub nut is ..284 ft pounds
What is the torque setting on the front axle of a CR85 Honda?
It is 46 lbf-ft.
what is the torque setting for front axle on 05 Ford 4x2?
The setting would be around 7 route in order to have a correct setting of axle.
What does a car front driveshaft do?
The front driveshaft does exactly the same as the rear one, drive the wheels.
The front axle nut torque setting is on a 2002 Buick Rendezvous?
192 lbft
What is the Torque setting for Daewoo Matiz hub bearings?
front hub 120nm i think
Front wheel spindle nut torque setting dodge Dakota?
185 ft.lbs/251 nm
Front wheel bearing torque setting on a Renault clio?
The front wheel bearing torque setting on a Renault Clio ranges between 112 to 174 ft lbs. One needs to use a 30 mm socket on a 1 inch air gun to loosen the nut.
What is the torque setting for the front wheel bearing nut on a 1998 ford puma 1.7?
290 nm front wheel bearing 1.7 puma
How do you remove the driveshaft from a 1999 Chevy s10 pickup?
Make sure truck is level or pointing downhill is even better. Remove the 4 bolts at the differential. Pry the driveshaft forward. Slide the front out of the transmission. Hold the front most piece with your hand as it comes out of the transmission. At re-assembly torque the bolts to 15 ft/lbs.
Front wheel bearing torque setting for 2004 ford focus?
Front wheel bearings are pressed in using a hydraulic press, no torque setting. However, the wheel hub retaining/axle nut that you need to remove and replace in order to change out the bearing needs to be torqued down to 233 ft-lb.
Where is the starter battery on a 2008 Fiat Ducato?
Under a panel in the floor in front of the passengers seat
