Front hub/wheel bearing torque is 190-210Nm.
290 nm front wheel bearing 1.7 puma
Front wheel bearings are pressed in using a hydraulic press, no torque setting. However, the wheel hub retaining/axle nut that you need to remove and replace in order to change out the bearing needs to be torqued down to 233 ft-lb.
Hub and bearing assembly and tighten the bolts to 61-78 ft. lbs. (83-107 Nm)
front bearing torque 151 ft lb rear bearing torque 63 ft lb plus 36 degrees
The torque setting for the front wheel bearing on a 2005 Astra typically ranges from 100 to 130 Nm (Newton meters) for the hub nut. It's essential to consult the vehicle's service manual for the exact specification, as it may vary based on the specific model and engine type. Always use a torque wrench to ensure proper tightening to avoid damage or failure.
Using new bolts, torque the front hub/bearing assembly to 96 ft-lbs.....
It is 175 ft lbs for the front wheel bearing of a grand cherokee
2003 SATURN L 300 front axle torque spec
what is the torque on front wheel bearings for 1998 honda accord
A torque wrench is not required to remove the bearing. It is required to apply the correct loading to a nut or bolt when assembling. Because the fixture may have been in place for some time a greater force may be needed for removal, because of corrosion or dirt, than the original torque setting applied.
Make and model would help.