Dana 44 Twin Traction Beam
Measure from center of front axle to center of rear axle.
plug is on the left front of axle housing. take a 3/8 drive to remove
According to the ( 1996 ) Ford Bronco Owner Guide : Axle code ( 19 ) is a Ford conventional ( non Ford Traction Lok / limited slip ) axle with a 3.55 ratio
yes
The slip yoke on the Ford Bronco is located on the rear axle rather than on the transfer case. This is the portion of the axle that allows it to flex.
On a full sized Bronco, it is located in front of the fuel pump between the frame rails near the drivers feet.
ckeck the solenoid on the passanger side front fender
A 1989 Ford Bronco II has a ( 2.9 liter / 177 cubic inch V6 engine )
3.73 8.8
Yes. The Bronco body style didn't change again until after 1989.
it should be on the dash in the drivers front corner and also on the door sticker on the drvers door
I believe that is a ( C6 ) 3 speed automatic transmission with the 351 in a 1989 Ford Bronco