answersLogoWhite

0

The oil plug size for a 2004 Chevrolet Silverado with a manual transmission is typically 3/8-inch drive for the fill plug and 1/2-inch drive for the drain plug. It's always a good idea to verify with a service manual or check the specific transmission model, as there can be variations. Make sure to use the correct tools to avoid stripping the plugs.

User Avatar

AnswerBot

2w ago

What else can I help you with?

Related Questions

What size is the is the drain plug on a 97 s10 manual transmission?

the size of drain plug and the oil level check plug is 17 mm on s-10 1999 manual transmission


What size is a 2002 dodge manual transmission fill plug?

17 mm


How do you fill transmission fluid for manual 05 Nissan sentra?

there should be a fill plug on the side of the transmission case. its a bolt the size of a quarter.


Where is the oil drain plug located on a 1993 Ford XLT Ranger 5 speed manual transmission?

On the left side of the transmission, near the rear. It's about 22-24mm in size. The transmission fill plug in also the same size, and is located a few inches above the drain plug.


What is the size of the drain and fill plug on 2005 jeep wrangler 6 speed manual transmission?

Drain plug is hex 17mm; fill plug is hex 13mm


What size transmission in 1989 silverado 1500?

4l60e


What size hex head is a transmission drain plug for a 1996 gm sonoma 2.2 manual trans?

17mm (works for a 1998)


What is the Size of 04 silverado oil drain plug?

The original engine oil drain plug wrench size should be 15mm.


What is the size of a 2004 Jeep Wrangler Manual Transmission fill plug?

17mm allen wrench, the transfer case takes a 10mm allen.


What size transmission is in your 1998 K2500 Silverado 4x4?

That would be a 4L80E


What size wrench for drain plug on transmission on a Honda gl1500?

The drain plug on the transmission of a Honda GL1500 typically requires a 17mm wrench. However, it's always a good idea to double-check the owner's manual or inspect the plug directly to confirm the size, as variations can occur. Make sure to have a proper wrench on hand to avoid rounding the plug.


What size socket for transmission fill plug 2000 rodeo?

For a 2000 Isuzu Rodeo, the transmission fill plug typically requires a 10mm hex socket. It's important to ensure you have the correct size to avoid stripping the plug. Always consult your vehicle's manual or a reliable source for confirmation before proceeding with any maintenance.

Trending Questions
Where is computer located in 1992 Chevy Lumina Z34? What is the spark plug gap for a 1998 mustang 4.6l v8? If a car stops to avoid hitting a cat and you rear-end it are you 100 percent at fault? Can a 1992 crown Victoria transmission fit in a 1993 Lincoln mark VIII? What part is needed to repair turn signals and hazard lights that went out at the same time and where is it located and how do you replace it on a 2004 Chevy Malibu? Why does the window-lift motor on the drivers side of a 2002 Ford- windstar click but will not go up? How hot is normal for a new alternator to get when idling for an hour after replacing it and the battery on a 1993 Buick Skylark? How many types of cars wheel nuts? Where to locate diagnostic code reader 93 geo prizm? What is the gear ratio for a 1974 Plymouth Barracuda with automatic transmission? Where is the map sensor on 2006 Chevrolet Aveo? How do you locate catalytic converter 2000 ford explorer? How do I reset the inertial fuel cut off switch on a 97 mark viii? Your 2002 sebring convertible has a rough idle and stalls at lights or when you slow down to turn a corner Why? How do you remove the glove box on 2001 jetta? How much should it cost to tune up a 2000 expedition with a 5.4 Triton engine? How do I replace electric fuel pump in 1998 gmc safari van? What is the part called next to valve cover for 96 olds aurora? Can you access your fuel pump on your 1997 Chevy Lumina without dropping the tank? Where is the 1999 dodge ram 1500 5.9 liter camshaft sensor location?