answersLogoWhite

0

DEXRON-III automatic Transmission Fluid. 2.4 QTS.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How do you change encoder motor on a 2001 blazer?

hi this is peter i have a 2001 chevy blazer and how do i change the encoder motor on the transfer case? thanks


What fluid goes in a 1990 K5 CHEVY blazer transfer case?

Dextron II


How much fluid does a 95 Chevy blazer 4.3L transfer case hold?

11.2 quarts


Does trans and transfer case share the same fluid on a 01 blazer?

No they do not. There is a seal between the transfur case and transmission to stop the transfur of fluid from 1 to the other.


How do you remove the transfer case from the transmission in a 1996 Chevy blazer 4x4?

Remove all wires attached to the transfer case. Remove the driveshafts. Drain the fluid out of the transfer case. Place a transmission jack under the transfer case. Unbolt the transfer case from the transmission. Unbolt the crossmember the transfer case rests on.


1996 Chevy Blazer transfer case?

A 1996 Chevy Blazer Does have a transfer case IF it is equipped with 4 wheel drive


What is the capacity of the transfer case in a 2001 Blazer FWD 6cylinder?

2.5 Quarts, this is also for almost every chevrolet.


What type of fluid is use in transfer case of a 2001 ford f150?

Motorcraft MERCON automatic transmission fluid


What fluid do you put into a 1985 Chevy blazer K10 4 speed 4x4?

transmission- 80-90w gear oil transfer case - atf tranny fluid


Do you need to keep fluid in the transfer case of your 1985 Chevy k5 blazer even if you dont use the 4 wheel drive?

That is a must, It has to have fluid in it are it will burn up.


Where is the automatic transmission fluid temperature sensor located on a 1997 Chevy Blazer S-10?

The automatic transmission fluid temperature sensor on a 1997 Chevy Blazer S10 is located on top of the transfer case. It is in the engine compartment.


Transfer case for 83 full size blazer--305 what type of fluid for the transfer case?

Every new process transfer case I have ever worked on took 80\90, which you can identify by smell. My '84 Jimmy with a 700R4 trans uses ATF in the transfer case. Easy enough to tell when you open the fill plug, or if changing the fluid, you'll see when draining.