answersLogoWhite

0

another 95 Geo- maybe a Ford aspire, a old Dodge colt or a lawnmower.

User Avatar

Wiki User

19y ago

What else can I help you with?

Related Questions

What is the procedure for tightening the automatic transmission bands on a 1995 4-cylinder Metro?

It isn't possible. You'll need to have the transmission rebuilt.


What is the weight of a transaxle from a Geo Metro?

The engine and transmission of a manual 3 cylinder weighs 135lbs.


Is a automatic transmission from a 95 Geo Metro interchangeable with a 98 Geo Metro?

Yes it is. Any Metro transmission made after the year 1994 will fit in your 98 Metro.


Where is the Engine serial number on a 1.0 liter 3 cylinder geo metro engine?

On engine casing, passenger's side, on flange that bolts to transmission. Probably covered with engine gunk.


Will a transmission from a 1991 Geo Metro fit into a 1998 Geo Metro?

No, a 91 metro transmission will not fit in a 98. A 91 will fit any metro between 1988 - 1996 though. After 1996 a lot of Metro's became 4 Cylinder which made them different from the previous generation metros. It may fit if the engine sizes are correct (1.0 litre 3 cylinder to the same but do not mix and match).


What automatic transmission is in the 2000 Chevy Metro?

TH125 three speed.


Did the Austin metro come with automatic transmission?

yes... on the 1.3 ltr engine methinks.. worked on a H reg bout 15 yrs ago..


Does a 1992 Geo Metro have an interference engine?

yes, if it's a 3 cylinder Mr Geo Metro yes, if it's a 3 cylinder Mr Geo Metro


How do you change a manual transmission over to an automatic in a 1991?

Sell '91 Metro manual. Purchase '91 Metro automatic. You'll be less than $500 out of pocket which is a lot less than a serviceable automatic will cost.


Where can you find a diagram of an engine?

where can you find an engine diagram of a geo metro 3 cylinder 1.0L engine


Where do you add transmission fluid to a 1998 Chevy Metro Lsi with automatic transmission?

To add transmission fluid to a 1998 Chevy Metro LSI with an automatic transmission, locate the transmission dipstick tube, which is typically found near the back of the engine compartment. Remove the dipstick and use a funnel to add the appropriate type of transmission fluid through the tube. Make sure to check the fluid level with the dipstick after adding to ensure it is at the correct level. Always consult the owner's manual for the specific type of fluid recommended.


Is it possible to replace a automatic transmission in a 94 4 cylinder probe with a 93 5-speed 4 cylinder trans?

Hey Jeremiah==It is possible but VERY expensive. GoodluckJoe I have not done this but one time I replaced a motor in a 1992 GEO metro 5speed with another metro motor from an automatic I had to remove the torq converter and flywheel and put the flywheel and clutch on it from the oringinal one I had on it and it worked. hope this might help a little.