0
What else can I help you with?
What would cause the 1992 Corvette's Oil Temperature Gage to continuously read zero Is there a related system schematic available to troubleshoot Where is the sensor probe located?
== ==
How high should the pressure gage read on an in ground pool sand filtering system?
12-16 pounds when it gets toward 20 pounds the pool needs to be backwashed
How do you check the oil pressure?
You need to remove the oil sending unit and install a oil pressure gage in it's place then start engine and read gage. Iwould tell you were the sending unit is but you did not say what you are working on. You need to remove the oil sending unit and install a oil pressure gage in it's place then start engine and read gage. Iwould tell you were the sending unit is but you did not say what you are working on. You need to remove the oil sending unit and install a oil pressure gage in it's place then start engine and read gage. Iwould tell you were the sending unit is but you did not say what you are working on.
What causes 1998 civic gauge to read over heating?
First off its a gauge not Gage and second the engine overheating would be the culprit their, genius.
What do oil pressure switch do?
monitor and read oil pressure. sending that info to the gage cluster.
Why wont your fuel gage read on your 1995 Hyundai excel?
Probably a bad sending unit (in tank)
How do you find gage pressure?
Gage pressure is the difference between atmospheric pressure and absolute pressure. If you fill your tire to 35 psi as read on a tire gage, this is the gage pressure. The absolute pressure inside the tire is the pressure of the atmosphere (14.7 psi normally at sea level) plus the gage pressure.
What has the author Richard Duane Read written?
Richard Duane Read has written: 'Field test of an experimental bracketing sight for the 12-gage riot shotgun'
What causes high engine idle and surges in the 1989 Corvette?
The cause of high engine idle and surges in the 1989 Corvette is due to..Read More
How do you take a reading with a caster camber gage?
A caster camber guage is one of the easier guages you can read. It is all digital and it can read 0.1 of a degree out of a 20 degree area.
Could coolant leaking from a water pump cause your engine to read cold at the gauge?
No, low coolant would cause the opposite.
What would cause my temperature gage to remain up past 260 degrees after removing the bad thermostat I didn't replace it just removed it. How do I get the gage to read proper temperature?
You can't do that. You can remove the center of the thermostat, the part with the spring, but there has to be something restricting the water flow or the water goes through the radiator too fast. It doesn't have time to cool down. The temp is probably right. If the gauge reads hot as soon as you turn the key on, before the engine is even warmed up I would suspect the temp sending unit has failed. Locate the sending unit and unplug it, the gauge should read cold, if so replace the sending unit.
