0
What else can I help you with?
What can cause tapping at the top of engine?
A loose rocker arm for a valve mite be a easy fix with a valve adjustment
Could a bad egr valve in a Chevy cause the engine not to restart after it has been running?
A bad EGR valve should not cause the engine to not start. There is most likely another problem that is causing the engine to not start.
Where is the egr valve located on a 1999 Chevy suburban and what are the typical symptoms of an egr valve failure?
EGR VALVE IS LOCATED NEXT TO THE TOP RADIATOR HOSE AT THE ENGINE, IT CAN CAUSE ENGINE TO MISS, STALL AND SURGE.
Where is the PCV valve on a 2002 Chevy Suburban 6.0 liter engine?
The PCV valve on a 2002 Chevy Suburban 6.0 liter engine is located in the engine. You cannot miss the valve.
What is a tapping noise by the intake manifold on a 2001 Chevy mrtro?
Cold engine it's the oil filter, get a high end filter with a pre lube valve. Hot engine cheap or wrong weight oil, or, bad oil pump.
What will cause zero compression in a newly rebuilt 30 degree over Chevy 305 engine Could it be bad valve adjustment?
Could be--valve not closing completely
Egr valve 1994 Chevy 1500?
The EGR valve on a 1994 Chevy 1500 is located on the top of the engine. If the valve becomes stopped, the engine could idle rough or stall.
Valve train noise big block Chevy when hot?
Engine running hotter then 220 degrees can cause valvetrain noise. Bad fuel can also cause valve noise / PINGING sound. Ignition timing to high / Advanced to far, can also cause engine noise.
How can you fix gy6 engine tappind noise?
To fix tapping noise in a GY6 engine, first, check the valve clearances and adjust them to the manufacturer's specifications, as improper clearance can cause tapping. Next, inspect the camshaft and valve lifters for wear or damage, replacing any faulty components. Additionally, ensure that the engine is properly lubricated, as low oil levels or dirty oil can contribute to tapping sounds. If the noise persists, further investigation into the bottom end or other internal components may be necessary.
What would cause a 1996 Mazda 626 to a make metal tapping lifter noise?
metallic tapping that becomes faster as the engine speed increases indicates valve tapping. one or more of your valves clearances are misadjusted. to help you find out which one it is cut a small section of hose, put one end to your ear and place the other end on different spots along the rocker arm cover, where the sound is loudest is where the problem valve is. purchase a repair manual for your car for valve clearances and specific valve adjustment procedures.
What is causing a tapping noise in a Detroit diesel 60 series engine?
Tapping in a diesel engine often means a valve lifter is beginning to fail. It can also mean that sub quality fuel is being used.
What is the problem with the no 1 lifters tapping in Chevy small blocks usually the result of?
Worn valve train starting with the camshaft lobes.
