remove plastic trim piece from radio and air controlls, remove 4 screws to remove radio, install din to din and a half adapter(plastic piece picked up at any place selling car audio equipment) . wire adapter harness(adapter to plug new radio into vehicle w/o having to hard wire radio to vehicle, also purchased at audio store) to new radio harness plug radio in, verify connections, install radio into new din housing install plastic trim, enjoy.
yes! run it to the trunk
get the after market wiring harness
Go to http://www.crutchfield.com/ They have all kinds of installation kits.
that wire is for the radio dimmer. when you turn on your headlights the radio dims so your not blinded at night. Some aftermarket stereos have a place to hook this wire up and some don't.
Yes, when installing an aftermarket radio in a Mazda Millenia with a Bose stereo system, a bypass harness is typically needed. This is because the factory Bose system uses a unique amplifier setup that may not be compatible with standard aftermarket wiring. The bypass harness allows for proper integration of the new radio with the existing Bose system to ensure optimal sound quality and functionality. Always check the specific wiring requirements for your vehicle model and aftermarket radio.
You will need a special wire harness. You can get it along with instructions and support at http://www.crutchfield.com/
You have to go purchase an aftermarket wiring harness. that will plug into the factory harness then you can wire it to the aftermarket radio.
Must be that you are using the old speaker wiring that is COMMON GROUND wired. Aftermarket Radio will not like that sort of wiring for speakers. You need to run new wires at least to the rear speakers or I would do all 4 just cause the wiring is old.
yes you can install an aftermarket radio in a GM vehicle that is equiped with a theft lock radio. the radio itsel has the theftlock not the car so you can install any aftermarket radio in the car. There may be some other parts that you may need to install an aftermarket radio such as a dash kit, wiring harness and antenna adaptor. If your vehicle is a newer model with Bose and onstar, you may need an integration kit made by PAC-audio.
if its for your aftermarket radio it shold be in the back of the radio also check your fuse pannel
yes
Please visit my bio for access to my Saturn help site. here you will find a diagram of the factory wireing to assist you in installing your aftermarket radio.