yes! run it to the trunk
yes
Installing a CB radio in a Chevy Impala begins which installing the mount and location a suitable power source. The radio is then mounted to the dash, wired up, and the antenna connected.
bypass the factory amp
You have to go purchase an aftermarket wiring harness. that will plug into the factory harness then you can wire it to the aftermarket radio.
yes
Many aftermarket companies sell adapters for aftermarket wire harnesses. They have the original factory harness at one end and you cennect that to the harness that came with the radio. Check your local car audio installer.
get the after market wiring harness
two orange cables
if you are using an aftermarket wiring harness hook up the remote turn on wire on the new radio it should be blue with a white stripe to the harness also has a blue and white stripe and plug it in this wire turns on the factory amplifier if you are not using a harness you will have to locate the internal amplifier wire of the radio and connect that to the remote turn on on the aftermarket radio = answer = the inernal apm power wire is white on the black wire harness ANSWER if you dont want to use the factory amp. just run new speaker wires to each speaker.
Please visit my bio for access to my Saturn help site. here you will find a diagram of the factory wireing to assist you in installing your aftermarket radio.
Go to http://www.crutchfield.com/ They have all kinds of installation kits.
that wire is for the radio dimmer. when you turn on your headlights the radio dims so your not blinded at night. Some aftermarket stereos have a place to hook this wire up and some don't.