THE ONLY POSSIBLE ANSWER IS: MAYBE
You need to provide the following information:
you have put a new head gasket on it.
If it was removed then YES.
No
By removing the oil pan and cleaning the surface and installing a new gasket.
take it out then replace it
It is no possible for a human to replace its head.
You may have a head gasket leak. Remove your radiator cap and warm truck to normal operating temp. Look into radiator if you see air bubbles coming out you most likely have a head gasket leak. You will most likely need to replace the head gasket. Good luck, JQ
My husband has the same truck and it only has 90,000 miles on it and he blew a head gasket yesterday. Do you have any suggestions?
Trouble code P0102 means: MAF Sensor Circuit Low Frequency Try replacing the MAF sensor
If you look up under the back of the truck at the rear end housing, you will see a round plate with at least 10 bolts in it. Take all the bolts out. When you remove the plate grease will run out. Clean old gasket off, replace with new gasket, Put plate back on and fill with grase.
your crank sensor has absolutly nothing to do with the ability of the engine turning over. I would look at the wiring to the starter.
Because if you have used a pattern part they sometimes will work from new