answersLogoWhite

0

What else can I help you with?

Related Questions

Can ignition coil cause an engine to not start?

Yes, a faulty ignition coil can prevent an engine from starting. The ignition coil is responsible for converting battery voltage into the high voltage needed to create a spark at the spark plugs. If the coil is malfunctioning, it may not produce the necessary spark, leading to misfires or a complete failure to start the engine. Other components may also contribute to starting issues, but a defective ignition coil is a common culprit.


What does the ignition relay do?

The ignition relay is an essential component in a vehicle's starting system. It acts as a switch that controls the flow of electrical power to the ignition system, allowing the engine to start when the ignition key is turned. By providing a direct connection between the battery and the ignition system, it helps to ensure that the necessary voltage reaches the ignition components, enabling smooth engine operation. Additionally, it protects the ignition switch from wear and damage by handling the higher current required to start the engine.


What would cause the check engine light to remain on in a 2005 grand am before you start the ignition?

The light should be on before starting, and for 3 seconds after starting, as a bulb check.


Why my car's engine vibrates heavily on starting in the morning?

Could be may things, excessive cylinder wall clearance(worn engine), I would start with a tune-up.


How engine starts?

an engine needs a primemover force to start. that is, a sufficient-initial external force. thats why, we kick the kicker of the bike inorder to put it an external starting force. in case of self starting engines, also in cars, there is a starter motor to give up this external starting torque when we push the ignition switch or the ignition key.


Peugeot 406 difficult start in the morning Takes about 8-10 turns of the key before engine starts but starts again no prob The longer you leave it the more difficult it is to start What is the prob?

The difficulty in starting your Peugeot 406 in the morning could be due to several issues, such as a weak battery, faulty fuel pump, or issues with the ignition system. If the engine starts fine after the initial struggle, it may indicate that the fuel system is losing pressure overnight, possibly due to a leaking fuel injector or a failing fuel pump. Additionally, worn spark plugs or ignition coils might contribute to the hard starting. It's advisable to have the fuel system and ignition components checked for any faults.


What are symptoms of a ignition coil?

A bad ignition coil normally won't allow your engine to start given there is no spark. If it is starting to go bad, it causes misfiring which can be noticed as a stutter, or random shake of the engine. Check the ground of the coil before replacing it.


You have 97 astro van and in the morning lately when you start your van it will not start unless hit the gas pedal?

sounds like a flooding problem .I have a 97 astro van and I used to have starting issues in the morning when it was cold and raining outside.my issue was heavy dew that was dissabling my ignition system due to too much moisture in my distributor cap.After I changed my distributor cap and rotor button all of the morning starting problems left and never came back.If the ignition system is not up to par the engine can flood very easy because the gas is not been burned properly until the dew in the distributor is burned off.


Why does your 97 Buick lesabre not start sometimes?

There are countless different causes of an engine not starting, but in general, if the engine is receiving fuel, has ignition and compression, it will start. Begin with the basics. Next time it won't start, try a little starting fluid. If the engine runs briefly with starting fluid, you have a fuel delivery problem. Then go on from there. The only way to find a problem like that is to break it down. Check your Cam Sensors sometime they have a loose connection, your engine has 2 sensors a primary and secondary if the primary is the problem your engine wont start if its the secondary i will start but will run rough


What is a wet start in turbine engines?

Normally when starting a turbine engine, the starter is used to get the turbine up to operational speeds, then fuel is pumped in with the ignition active. A "wet start" is a start where the engine is being started with a quantity of fuel already pooled in the engine (perhaps the result of a previous failed start) or the pilot delays ignition beyond what is normal and allows fuel to pool in the engine before ignition. Wet starts can result in a fire plume or a loud bang, and may damage the engine. The most dramatic damage will be to the compresser turbine blades due to pressure and heat failure.


What are the possible reasons for difficult starting of a diesel van in the morning?

Difficult starting of a diesel van in the morning can be attributed to several factors, including cold weather, which can thicken the engine oil and affect fuel flow. A weak battery may struggle to provide enough power for the starter motor, especially in low temperatures. Additionally, issues with the glow plugs, which preheat the combustion chamber, can hinder ignition. Lastly, fuel quality or contamination can impact the engine's ability to start smoothly.


How do you unlock steering wheel on PT Cruiser?

If you have a remote starter, you can shut it off normally, remove the key from the ignition, and then proceed to start it up remotely, after which you can return the key to the ignition and turn it to the engine mode, NOT the starting mode.