answersLogoWhite

0

What else can I help you with?

Related Questions

How do you fix misfire on Chevy 94 suburban?

Check the spark plug for that cyclinder. Clean and regap it, or simply replace it.


Can you clean the oxygen sensors on a Chevy blazer?

No, they will need replaced if defective.


How do you clean the wheel speed sensors on a 2001 Chevy Impala?

the wheel speed sensor is all part of the wheel bearing hub assembly you cannot clean them you have to replace the hub assembly its not that hard of a job gm cars are known for this problem.


What can be used to clean a 1995 Chevy blazer transmission filter?

You don't clean them - you replace them.


How do you reset the brake pad warning on a Mercedes C180?

remove the sensors and clean it. then put it back. if the warning light is still replace the sensors it is cheap


How do you clean a mass air flow sensor on a Chevy Suburban?

Purchase a can of mass air flow cleaner and follow the directions on the can. Don't try to clean it with anything else!


How do you replace the evaporator on a 1997 Chevy silverado c1500 ext cab?

how to clean evaporator on 1997 chevy 1500


Can you clean the oxygen sensor on a 2003 Chevy Suburban?

An ox sensor is a sensitive component it can easily b damaged it should b replaced at 65 to 75,000 miles for optimum performance. Corrosion ,acids and temperature plus abrasion from carbon take its toll. Replace the sensor.


How do you change the transmission fluid in a 1992 Chevy Caprice?

You will need to drop the transmission pan and replace the gasket. While you're at it, replace the filter and clean the pan.


Why would you have antifreeze in the oil of your 1996 Chevy Suburban engine?

That is a very common problem with the Vortec engines. You must REPLACE the Intake gasket and then change the oil and filter a few times in a roll after letting the engine run a few minutes each time until you get the engine oil to clean up.


How do you replace the gaskets on intake manifold for 2002 suburban?

To replace the Suburban manifold gaskets, unhook everything on the manifold, from fuel lines to vacuum hoses. The manifold needs to be unbolted then removed. Clean the old gasket material, then install with a new gasket. Make sure to use factory specs when torqueing down the bolts.


What would cause the 2001 Chevy Suburban to die when stopping?

Need to look at the throttle plate and see if it's dirty, if so clean both sides until it's shiney and clean. There's a chance the torque converter is not unlocking. But that is rare.