0
What else can I help you with?
Can I flat tow an 1989 Pontiac trans am?
The 1989 Pontiac trans am is a classic automobile. Yes, you can flat tow a 1989 Pontiac Trans Am.
Why would a 1989 ford ranger lose its power after replacing the ICM ignition control module?
Because you didn't change the rest of the ignition system. Plugs, Wires, Rotor, and Cap are a must for ICM replacement.
How do you replace ignition cylinder on a 1989 Toyota Camry?
To replace the ignition cylinder on a 1989 Toyota Camry, start by disconnecting the negative battery cable to ensure safety. Remove the steering column covers by unscrewing the screws, then locate the ignition cylinder. Insert the key and turn it to the "Run" position while pressing the release tab on the cylinder to pull it out. Finally, install the new ignition cylinder by reversing the steps, ensuring it locks in place securely.
How to replace 1989 Jeep ignition cylinder?
To replace the ignition cylinder in a 1989 Jeep, start by disconnecting the battery to ensure safety. Remove the plastic covers around the steering column by unscrewing any visible screws. Then, insert the key into the ignition and turn it to the "Run" position while pressing the release pin on the ignition cylinder, allowing you to pull out the old cylinder. Finally, insert the new ignition cylinder, ensuring it locks in place, and reassemble the steering column covers before reconnecting the battery.
How do you remove the ignition switch on a 1989 Chevy Corvette?
Remove the retaining ring from the top of your 1989 Chevy Corvette ignition switch. Slide the ignition switch out and remove the wiring harness.
How do you install ignition switch on 1989 Chevy G 10 van?
how do you install new ignition switch on 1989 chevy G10 van?
Where is the ignition module located on a 1989 ford ranger?
The 1989 Ford Ranger pickup truck ignition module is located on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.
Why does my 1989 Chevy 350 ignition module keep going bad?
If you're not using a heat sink grease between the module and the mount area try using some on your next replacement module.
1989 Pontiac sunbird?
What's exactly the question is?
What is the firing order for a 1989 Pontiac Firebird?
123456
How many feet long is a 1989 Pontiac le mans?
The 89' Pontiac LeMans is 12ft long
How do you change the ignition switch on a 1989 Chevy Blazer S10?
You will need to remove the retaining ring from the top of your 1989 Chevrolet blazer ignition switch. Slide the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.
