0
What else can I help you with?
Where is the ignition module located on a Ford Ranger XLT 2.3l?
1994 was the last year the Ranger used an ignition control module on the 2.3 and 2.5. The ignition control module was attached to the lower intake manifold.
95 2.3 ranger is it equipped with an ignition control module?
Yes ( according to motorcraft.com ) Motorcraft ( DY 959 ) Ignition Control Module for 1995 Ford Ranger 2.3 L - SOHC
Where is the ignition control module on your 94 ranger 2.3?
On the side of the intake manifold.
What kind of bolts hold the ignition control module in a 1987 Ranger 2.3L?
5.5mm bolts are the kind of bolts that hold the ignition control module in a 1987 Ranger 2.3L. However, 5.0mm bolts may also work.
Where is the location of the ignition control module on a 1993 Ford Ranger 2.3 dual ignition?
It is secured with screws at the fenderwell.
What is the Bolt size for ignition control module on a 1988 ford ranger?
4.5 mm but has to be deepwell
1989 Ford Ranger ignition module bolt size?
5.5 mm but takes a special tool to remove module the tool is 4.99 at auto zone just tell them what ur replacing and they will get you the o.e.m ignition module tool
Where is the ignition control modular on an 87 ford ranger?
The ignition module should be attached to the distributor with two small machine screws.
Where is the ignition module located on a 1989 ford ranger?
The 1989 Ford Ranger pickup truck ignition module is located on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.
Where is ignition control module on 94 ford ranger 3.0 6 cylinder?
On the lh side mounted to radiator
Where is the ignition control module located on a 1997 ford ranger 2.3L?
On a 1997 Ford Ranger 2.3L, the ignition control module is typically located on the driver's side of the engine compartment, near the firewall. It is mounted on the ignition coil bracket, which is situated on the side of the engine. To access it, you may need to remove some components for better visibility and reach.
Why did your 1990 ford ranger lose power while driving?
i replace the erg,tps,idle control module and ignition control module,and while driving past 30mph i loss power why
