Most of the vehicles I recall seeing had a plug at the very rear of the vehicle under the body. It's more toward the drivers side of the vehicle I think it was a 4 or 5 pin connector plug and it lays tightly to the body . Some of the pickups had them on the frame rail in front of the rear axle ,but there was none for some models.
2006 Dodge Dakota - Where do i find the trailer wiring harness
It should be by or under the rear of the vehicle.
If it does not have a factory installed harness - U-Haul has a kit with instructions to tap into OEM system
You can find a trailer wiring harness for a Chevrolet in a Haynes repair manual. The manuals are available at most auto parts stores.
You will find the tail light harness under the back of the vehicle. Unplug the harness and plug in the trailer harness between the two vehicle connectors. The kit should also contain instructions.
To wire trailer lights on a Suzuki XL7, you'll typically need a trailer wiring harness compatible with the vehicle. Start by locating the vehicle's taillight wiring harness and using a wiring diagram to identify the correct wires for the brake, turn signal, and running lights. Connect the trailer wiring harness to these wires, ensuring secure connections, and use a circuit tester to verify that the lights function correctly. Finally, make sure to ground the trailer lights properly to avoid electrical issues.
You can buy a trailer wiring kit that plugs directly into your Explorer taillight harness. It has everything you need, including directions, so that you don't need to be concerned about what to splice into. Check with any RV dealer or places where boats and trailers are sold.
Trailer wiring harness part #118382 - any local Auto Parts Store should care this.
check the bulbs if that does not work,check your wiring harness.i had the same thing happen to me and it was my wiring harness
To hook up a trailer wire harness on a 2008 Honda CR-V, first, locate the vehicle's wiring harness beneath the rear of the vehicle, typically near the tailgate area. Connect the trailer wiring harness to the vehicle's wiring by matching the color-coded wires, ensuring a secure fit. Use electrical tape or heat shrink tubing to protect the connections from moisture. Finally, test the connection by checking the trailer lights to ensure they function properly.
Auto parts store Buy a 5 wire to 3 wire converter On_mitch
It is the round connector, with a cover over it, about 6 inches left of and about at the same level as the hitch receiver.