answersLogoWhite

0

Somewhere in the engine compartment ( battery side ) you will find an EEC TEST connection for your OBD I / EEC - IV system

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

Where can I find a key code for a 1998 ford F150 truck?

take the truck to your local ford dealer. they can hook up their scan tool and read the code.


Where is the hook up forcode reader 2002 envoy?

Where to hook code reader 2002 envoy


Where do you hook up the obd2 code reader on a 1999 ford windstar?

The obd2 plug is under the knee board (under the column).


Where do you hook up an OBDII code reader on a 1985 lebAron?

Your OBD II code reader won't work on that vehicle.


Where is the dignostic eec-iv connector on ford E150 van located to hook code reader to?

you can find it on the inside of the passenger side fender by the battery under a usually black cover labeled as such


Where do you hook up a code reader to a 2000 volvo?

To hook up a code reader to a 2000 Volvo, locate the OBD-II diagnostic port, which is typically found under the dashboard near the driver's side, just above the brake pedal. Plug the code reader's connector into this port. Once connected, turn on the vehicle's ignition (without starting the engine) to power the code reader, allowing it to communicate with the car's onboard computer. Follow the reader's instructions to retrieve any diagnostic trouble codes.


Where do you hook up the code reader on a 2002 Suzuki XL 7?

If you are sitting in the steering wheel the hook up will be located by your right knee under the dash.


What kind of damage would be done to a 97 ford F150 if tow truck hooks cables wrong what could?

were did the tow truck hook the cables at ????????


Where do you hook an OBD code reader on a 1997 Mercury Cougar?

passenger side panel, above left knee


How do you diagnose check engine Chevy 2000 Monte Carlo?

you have to hook up a special reader to your computer to find out the code.


Where do you hook the code reader on a 1995 Dodge intrepid?

under the driver side of the dash, it is a square 6 pin connecter


How do you clear an error code on a Nissan forklift?

you get a code reader and hook it up to the fuse boc and it will say erase codes and u mass the green button.