0
Through low pressure port Buy a kit a Wal-Mart or auto parts comes with instructions
A/C Service ports are located under air filter box-remove air filter box and flex tube going
to engine-be careful-there are a few sensors in the area-also when re installing flex tube be sure it in installed correctly-air leaks will cause no start/rough idle/ ect. conditions
What else can I help you with?
How much freon do you put in a 92 Oldsmobile Cutlass Supreme?
The 1992 Oldsmobile Cutlass Supreme uses R12 freon and needs 36 ounces. R12 is no longer being made, but is still being recycled and is still available through online auctions.
Where do you put the coolant in the Oldsmobile cutlass supreme 1991?
You have to put it in the overflow tank.
Can you put any oldsmobile motor into a 1985 cutlass supreme?
No you can not put any Oldsmobile motor into a 1985 Cutlass Supreme. Each car has a motor that was designed specifically for that vehicle. So if you need to replace the motor in a 1985 Cutlass Supreme, you need to find the specific motor for that vehicle.
What is the oil capacity for a 92 Oldsmobile cutlass supreme?
actually it's 4.5 qts. but if you just put in 5 qts. with a filter change you will be fine.
1985 Oldsmobile cutlass supreme spark plug pattern?
My friend didn't put 'em back together right and we need a picture so we can tell how to put the on right. Thank you.
Were do you put freon in a Oldsmobile intrigue 1998?
never use it
What is the horse power put out of a 3.4L Oldsmobile motor 1994?
If the 1994 Oldsmobile with the 3.4 liter engine is the Olds Cutlass Supreme, the horsepower is 210. This car gets 19 miles per gallon in the city and 29 mpg on the highway.
Can i put a 1992 cutlass supreme digital cluster in a 1993 cutlass supreme?
yes the cluster works for 89 90 91 92 93
1994 Oldsmobile Cutlass Supreme Horn starts to blow when you put in the fuse If you push on the air bag it quits Help diagnose?
there is a short in the horn ring you need to take it completely apart
Installing belts in 99 Oldsmobile Cutlass?
Begin by loosening the tensioner pulley on your 1999 Oldsmobile Cutlass. Put your serpentine belt around the pulleys. Tighten the serpentine belt with the tensioner pulley.
Where is low pressure valve to put in 134a on a 1994 Oldsmobile Cutlass Ciera V6?
The low pressure valve to put in 134a on a 1994 Oldsmobile Cutlass Ciera V6 is on the passenger side of the engine compartment. It is about 12 inches below the alternator.
What freon do you put in a 82 Oldsmobile delta 88?
A 1982 Oldsmobile was built to use R12, it would need retrofitted to R134a..
