answersLogoWhite

0

on the 6 cyl it is either mounted on the distributor or on the driver side of engine compartment close to the firewall. If it is not distributor mounted it will be in the middle of a large alloy heat sink.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

Where is the ignition module located on a 94 Saab 900s?

where is ignt.mod. location


Where is the ignition control module on your 94 ranger 2.3?

On the side of the intake manifold.


What would cause a 94 chev to start when cold but not when warm?

look at the ignition module. a known trouble spot.


Where is ignition control module on 94 ford ranger 3.0 6 cylinder?

On the lh side mounted to radiator


94 Honda civic wont stay running fuses good has spark new ignition switch new ignition module new ignition coil?

Check Gas pump and relays


94 integra wont start you changed the coil and spark plugs?

check your distributor ignition module and go test it...


Where is the airbag control module located on a 94 f150?

it is above the gas peddle. Its blue and it has black foam wrapped around it. It is mounted vertical and pulls down with ease.


Where is the location of security module in 94 jeep grand Cherokee?

It is located in the console on a 95 jeep grand cherokee.


Where is the ignition module located on a 94 dodge Dakota?

That is the PCM on the driver's side fender.That is the PCM on the driver's side fender.


Location of a glow plug module in an Isuzu NPR 94?

The glow plug relay is on the drivers side of the truck in a relay box on the chassis frame behind the drivers side tire. which module is it?


Will a bed lid from a 97 ford f150 short bed fit a 94 f150 short bed?

No


Where is the ignition control module in 94 Dodge Intrepid?

The 1994 Dodge Intrepids (3.3 and 3.5L engines) don't have a separate ignition module. The Powertrain Control Module (PCM) controls the functions of an ignition module. The PCM is located under the hood on the engine. It's held in place by a stud bolt and push pin. There's a "60-pin" connector attached to the back of the PCM. If you're removing the PCM, you'll need to remove the stud bolt and push pin, and unplug the 60-way connector.