I have worked with my 1994 and 1995 models of 900 - presuming the same for newer models. The tensioner is located on theupper end near the firewall. I found it most easily managed by using a 1/2 inch breaker bar.
The tensioner has a spring in it that provides the correct tension for the belt. If it is too loose, replace the tensioner.
find the belt tensioner and use a rachet to oush the tensioner back
The 93 Acclaim has a serpentine belt. The tensioner below the alternator is what keeps the tension. If you have not tension I would replace the belt first and then check the tensioner.
Saab dealer quoted 1 hour to replace the serpentine belt. The cost of the belt was $60 canadian.
Has anyone ever really been far even as decided to use the belt tensioner on 93 plymouth ranger even go want to do look more like?
2006 Saab93 has a timing chain.
Lossen 17 mm bolt at botton of tensioner and screw 13mm bolt on tensioner stud untill belt is tight then re torque 17mm bolt !!
To loosen the serpentine belt tensioner on a 1993 Chevy Silverado, you'll need to use a wrench or ratchet on the tensioner bolt. Turn the tensioner counterclockwise to relieve tension on the belt. Once the tension is relieved, you can remove the serpentine belt from the pulleys. Make sure to note the belt routing for reinstallation.
lokks to be on the lower right side of engine
rotate the tensioner clockwise to release the tension and remove the belt then slowly release the tensioner. route new belt over the various pulleys according to the diagram under the hood again rotating the tensioner as to allow belt to fit in place and then slowly release the tensioner again.
3.0 L Sabb V-6 uses a timing belt. This belt must be replaced every 90,000 miles.
is there a fuse between alternator and battery on a 2002 saab 93