answersLogoWhite

0

The reservoir for the hydraulic clutch ( which takes DOT 3 brake fluid ) is located

in the engine compartment , by the drivers side fender / power distribution box

on a 1998 Ford Ranger

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

Clutch oil Mitsubishi?

clutch fluid. Small reservoir looking like the brake overflow reservoir only about 1/3 the size.


Where to add clutch oil in your 1997 Saturn SL?

It's going to look like your power brake reservoir. It is the reservoir for your clutch slave cylinder.


Where you put fluid in the car?

Engine oil reservoir, differential, radiator, power steering reservoir, brake fluid reservoir, windshield washer fluid reservoir, transmission or clutch.


Where is the clutch oil reservoir in a new beetle located?

After looking and consulting with techs, I found the reservoir to be included with the brake system. You should see a separate, unpressurized hose coming off the side (right) that leads down to the master clutch cylinder. This was on a 2004 VW New Beetle convertible.


Where is the low oil level sensor unit located on a 1994 ford ranger?

It should be located in the oil pan. On my ranger its on the drivers side.


Where do you put clutch oil for 1991 Ford Escort?

The clutch does not use oil, it uses DOT3 brake fluid. The clutch cylinder gets its brake fluid from the brake cylinder and is directly below it. Add fluid to the master brake cyliinder reservoir.


Where is the oil pressure sending unit located on a 1989 Ford Ranger?

located below the oil filter


Where is the oil drain plug located on the 2007 ford ranger 4 cylinder?

The oil drain plug is located on the bottom side of the engine of a 2007 Ford Ranger. It is directly on the oil pan.


Will low hydraulic oil in trans for a Chevy s-10 2.2 cause clutch not to engage?

There is no hydraulic fluid in the transmission. However, there is hydraulic fluid in the clutch system. If the clutch fluid reservoir is empty it would cause clutch not to operate.


Where is the oil plug located on a Ford Ranger XLT V6 engine?

the oil plug is located under the motor on the oil pan


Where is the transmission fluid reservoir on 1999 Chrysler sebring convertible jxi located?

The oil pan on the bottom is the fluid reservoir.


What is the difference between water injection and water flooding?

I do not think that there is any difference. Petroleum engineers normally inject water into an oil reservoir to maintain the reservoir pressure (and hence the ability of the reservoir to pump oil to the surface). In the process and if the water injection wells are properly located, the injected water normally sweeps (pushes out) out more oil effectively flooding the reservoir and increasing the amount of oil that is recovered from the reservoir. This incremental oil will otherwise be left behind in the reservoir. Hence, in an oil reservoir where the natural aquifer is large and strong enough to maintain the reservoir pressure, water injection is unlikely to significantly increase the oil recovery from the reservoir.