0
What else can I help you with?
What does a diagnostic code P0401 mean on a Ford Windstar?
P0401 means no flow at the dpfe sensor. Usually a bad sensor. or bad hoses from egr ports to dpfe.
What causes a P1405 Error Code on a 1998 Ford Windstar?
P1405 Ford - DPFE Sensor Circuit Upstream HoseProbably caused by Faulty DPFE sensor (EGR pressure sensor), or a plugged EGR tube
If a 2000 Ford Windstar had the alternator and fuel filter and fuel pump all replaced why would it still die like it is not getting enough gas?
Mine was doing this also and stalling bad. I found a broken vacuum line going to the DPFE sensor. The problem came back several weeks later. I cleaned the connections to the DPFE and MAF sensors with contact cleaner. Replaced the DPFE sensor, and found I had a broken clip on the MAF sensor connector (probably the actual problem. If you aren't getting enough air flow, or the computer thinks you aren't from bad sensors or connections, it adjusts the mixture leaner.
Can an egr valve or back pressure sensor or solenoid cause the engine to miss or run rough on a 1998 Ford Windstar 3.8 engine?
Yes.See "Related Questions" below for much more about the Windstar EGR / DPFE system.
What do trouble codes P0172 and P0171 mean on a 2002 ford windstar?
Get a can of mass air flow sensor cleaner and clean the maf sensor
Where is the DPFE located on a 2002 ford crown Victoria?
where is the DPFE sensor located on a 2002 ford crown victoria?
1996 Ford Ranger have a DPFE SENSOR?
YES - www.motorcraft.com lists a DPFE sensor for all available engines on a 1996 Ford Ranger
Where is the maf sensor located in a 2002 Ford Windstar?
In a 2002 Ford Windstar, the Mass Air Flow (MAF) sensor is located in the air intake duct, between the air filter and the throttle body. It is typically mounted on the air intake hose and can be identified by its electrical connector and sensor housing. To access it, you may need to remove the air filter box or loosen the clamps on the intake duct.
How to get rid of engine light in a 2002 ford windstar they say its a maf?
See "Related Questions" below for information about the Windstar's Mass AirFlow (MAF) sensor.Resolve the problem and the Check Engine Light (CEL) will go off after a few drive-cycles.NOTE: Do NOT automatically replace the MAF until you know for sure it has failed.They get dirty and a thorough cleaning will work to resolve the problemThey're expensive - so check other options first
How do you fix a 1998 Ford Ranger pickup with an error code of 1401?
P1401 is DPFE sensor circuit high, check out this tutorial to replace the sensor on your Ford
When was Ford Windstar created?
Ford Windstar was created in 1994.
Egr dpfe sensor on the 99 buick century custom?
Ford is the only American car company that uses a DPFE sensor. GM dpfe sensor are built into the EGR.
