they are located under intake manifold The #1 sensor is located in the front of the engine and the #2 sensor is located in the back of the engine. Remember to replace the intake gaskets once you replace the sensor/s. The total time it took me to pull the intake and locate the bad sensor was about 6 hours. Hope this helps
Yes, there is a fuel sensor in a 2000 GMC Sierra.
Location of knock sensor 1991 GM sierra 350 2500?
where is knock sensor on a 2001 sierra 5.3 2wd 1500.
To change the knock sensor on a 2000 GMC Sierra V6 4.3, first disconnect the negative battery cable to ensure safety. Locate the knock sensor, which is typically found on the engine block, near the intake manifold. Remove the electrical connector and unscrew the old sensor using a socket wrench. Install the new sensor by screwing it in place, reconnecting the electrical connector, and then reattaching the battery cable.
Type your answer here... Where IS Cambshaft sensor in 2000 gmc 1500 and what does it do
The knock sensor is located under the Intake Manifold and there is a knock sensor 1/ knock sensor 2 on this model,the 2 is the one in the rear.
the knock sensors are located in the top of the engine block. The intake has to be removed to get to the sensors.
knock sensor location is under the intake manifold you have to remove intake their is two knock sensors front and rear
The knock sensor is on the starter side of the engine. It is abut half way between front and back.
How do you rebuild a differential for a 1981 GMC pickup?
It is screewed in the engine block over by the starter.
On engine block