The ABS Control Module on a 1990 Ford Thunderbird is in the electronics tray in the trunk. It hangs from the rear speaker deck.
Most likely it is the Ignition Control Module.
Yes ( according to motorcraft.com )
The Ignition Control Module on a 1996 Ford Thunderbird 4.6 is located inside the EFI or Electronic Fuel Injector. The EFI is the carburetor. Look for a cord that has a connector that resembles an HD Cable.
A 1990 Ford Thunderbird Super Coupe weighs approximately 3,600 pounds.
This answer is for a 1990 ford thunderbird 3.8 NA it is locate on the left hand side of thet transmission This answer is for a 1990 ford thunderbird 3.8 NA it is locate on the left hand side of thet transmission This answer is for a 1990 ford thunderbird 3.8 NA it is locate on the left hand side of thet transmission
It is in the trunk Left side behind the panel.
The 1990 Ford Thunderbird was developed on Ford's Mid-Size North American Project 12 platform. This Thunderbird featured a more aerodynamic body that was shorter in overall length in comparison to the earlier Thunderbird, but with a longer wheelbase.
On a 1990 Ford Thunderbird : There should be an EEC TEST connection in the engine compartment for the OBD I , EEC IV system
On a 1990 Ford Thunderbird : The 3.8 liter V6 engine distributor rotor turns COUNTERCLOCKWISE
Under hood, driver side, front side of strut tower, mounted on fenderwell For a 5.0L engine
UNDER HOOD, CENTER, UPPER ENGINE AREA, MOUNTED ON TOP CENTER PASSENGER SIDE OF ENGINE
i replace the erg,tps,idle control module and ignition control module,and while driving past 30mph i loss power why