It is normally attached to one of the 15 mm head bolts holding the ac compressor bracket or the equivalent on the passenger side of the engine.
The smaller wire usually attaches to the body either at the deck lid hinge or directly to the sheet metal beside the battery.
Call autozone and they will have a diagram of where this is. also in the haynes manuel the is a location showed for you
unscrew them like a lugnut
There isn't one, the switch powers it directly
Yes. Cradles were all the same till 88.
The pattern is as follows |642| |===] FWD^ |531|
84-88 and they made prototypes for the 90's but never manufactured them.
An oil pump Or do you mean the type?
my 88 fiero had two valves stuck, one on cyl 2 and one on cyl 3.. if it would start it was on one or two cyl... or he crank senor might be bad
There is one on each side, directly in front of the front tires, visible from under the car.
It goes around three pulleys and is very easy. it will work fine if you guess
All years of Fiero heater cores are the same, with the only difference being A/C equipped or non A/C equipped. Go to fierostore.com and you will find what you are looking for.
it's a long tedious process. heres a video that can show you how. www.youtube.com/watch?v=3CzDk9wswG4