The blend door vent on a GMC Sonoma is typically located within the dashboard, behind the HVAC (heating, ventilation, and air conditioning) system. Accessing it usually requires removing the dashboard or the center console to reach the HVAC housing. The blend door controls the mix of hot and cold air entering the cabin, so if you're having issues with temperature control, it may be related to this component. For precise location and access steps, it's best to consult the vehicle's service manual.
The temperature valve actuator is located on the front of the heater case
The 1995 General Motors/GMC Sonoma has the door lock motors and actuator assemblies. These are located in the driver and passenger side doors, behind the door trims.
The blend door actuator on a 2002 GMC Sonoma is typically located behind the dashboard, near the center console area. To access it, you'll often need to remove the glove box and possibly some panels to reach the HVAC housing. The actuator is usually mounted on the side of the heater box and is responsible for controlling the temperature of the air entering the cabin.
Driver side below the dash and right next to vent it has a hole in it that ties to a shaft inside the vent i think there is two screws that hold it in place.
Center front underneath plastic trap door.
No, a 95 GMC Sonoma does not use a timing belt on it. The 95 GMC Sonoma uses a timing chain on it.
need to know were the blend door actuator is for a 2002 gmc yukon on the drivers side , dual climate controls, rear air and heat
The GMC S-15 became the GMC Sonoma in 1991.
bs
The fuel filter is under the truck on the frame. Near the drivers door.
Where is the timing connector on a 1995 gmc sonoma
will the 2.2 crossmember on a 1994 GMC sonoma fit on a 1994 GMC sonoma 3.4