It is located on the fire wall under the hood passenger side next to the wiper cover.
the resistor is gonna be right off the blower motor attached to the blower motor by a wire harness should be by the heater core
can be the heater blower motor resistor located in either the ductwork or under hood near blower motor on firewall
The blower motor resistor is located on the right hand side of air inlet(plenum). Where is the air inlet? Where is the (plenum)?
A malfunctioning blower motor resistor will cause the blower motor not to work. When the resistor is bad the blower motors will not turn on.
The a/c heater blower motor resister is located in the vehicle on the passengers side inside the housing next to the blower motor...............Remove the blower motor resistor wire harness connector.Remove the blower motor resistor screws.Remove the blower motor resistor.
behind the steering wheel
To replace the blower motor in a Plymouth Sundance, first disconnect the battery to ensure safety. Remove the passenger side dashboard panel to access the blower motor assembly, which is typically located under the dashboard. Unplug the electrical connector and unscrew the mounting screws to remove the old blower motor. Install the new motor by reversing the steps, ensuring all connections are secure before reassembling the dashboard and reconnecting the battery.
Resistor is a separate unit from the blower motor
Generally the blower motor resistor is found close to the blower motor. It relies on the blower motor to keep it cool.
The blower motor resistor has failed.The blower motor resistor has failed.
Fig 15 Blower Motor ResistorNOTE: The blower motor resistor is located on the lower right side of the heater housing.REMOVAL# Remove lower right underpanel silencer/duct. # Disconnect wiring connectors on blower motor resistor. # Remove blower motor resistor retaining screws. # Pull blower motor resistor out of heater housing.
The blower motor speed resistor is burned out. Keep in mind that in many cases the speed resistor burns out because the blower motor is failing and drawing to many amps. So if the new resistor burns out soon, next time replace the blower motor also.