0
The camshaft position sensor on a 2002 Chrysler Concorde is located on the engine's cylinder head, typically near the front of the engine, close to the timing cover. It may be necessary to remove some components or covers for easier access. Always consult the vehicle's service manual for specific details and diagrams for your engine type.
What else can I help you with?
The price of a cam sensor for a 2002 Chrysler Concorde is?
Depending on the specific submodel (LX with 2.7L V6 or LXi/Limited with 3.5L V6), the average price for a cam position sensor will be around $50-70 if you buy from an auto parts store.
Where is the camshaft position sensor located on a 2002 Chrysler Concorde?
The crankshaft sensor is located on the passengers side of the transmission housing, above the differential housing. The bottom of the sensor is positioned next to the drive plate. The cam sensor is located on the left bank cylinder head
Where is the camshaft position sensor located on a 2002 Chrysler concorde 3.5L?
The crankshaft sensor is located on the passengers side of the transmission housing, above the differential housing. The bottom of the sensor is positioned next to the drive plate. The cam sensor is located on the left bank cylinder head
You have 1994 Chrysler Concorde how can you tell if your cam shaft sensor is bad?
call around to auto part stores if you have a autozone near you they can check them for free
Can a cam shaft sensor problem cause a 2002 Chrysler Sebring to stall and not restart?
Yes.
Where is the cam sensor on a 2000 Chrysler Concorde?
It is mounted on the front of the engine slightly to the right as you look from the front. There is a clip attached to it. 1 Bolt holds it in.
Where is the cam shaft sensor on a 2002 Chrysler PT Cruiser?
Drivers side of motor, just below valve cover.
Is there a cam sensor in 2002 dodge with 318?
A 2002 Dodge does have a cam sensor, but the 318 was not offered after 2001.
How do you adjust the camshaft position sensor in a Chrysler Sebring?
The cam sensor is not adjustable.
Where is the cam sensor for a 2000 Chrysler cirrus 2.5 engine?
It is inside the distributor. You have to replace the distributor to service the cam sensor.
What is wrong if a 1996 Chrysler Sebring computer reads 'cam position sensor no signal'?
There is a problem with the cam sensor or the wiring to it.
Where is the cam sensor on a 1997 Chrysler LHS?
Cam sensor is on the driver side front of the engine, mounted into the cam housing.. you may have to take the intake off to access it...
