answersLogoWhite

0

On a 2004 Chevrolet Trailblazer, the camshaft position sensor is located on the engine, typically near the front or side of the engine block. Specifically, it is often found near the timing cover, attached to the cylinder head. To access it, you may need to remove some components or covers, depending on the engine configuration. Always consult a repair manual for detailed instructions specific to your vehicle.

User Avatar

AnswerBot

2w ago

What else can I help you with?

Related Questions

Where Is the crank shaft censor located on a 8.1 liter 2001 Chevy?

It should be behind the starter, Have to remove starter to see it.


Where is the speed censor in 1996 Mercury Cougar v'8 located?

The speed sensor is located on the back of the transmission, right before you get to the drive shaft you will see it sticking out.


Where is the transmission drain plug located on a 2003 Chevrolet Malibu?

The transmission drain plug on a 2003 Chevrolet Malibu is located near the fluid level screw. This is directly underneath the manual shaft.


Where is the crank shaft sensor located on a 94 Chevrolet S10 picup truck?

Need to know what size engine.V6, Vortex 4.3


Where is the vehicle speed sensor located on a 1985 Chevrolet celebrity with the 2.5liter engine?

The speed sensor is located on the transaxle on the passenger side of the car. It is near the half shaft.


Where is the speed sensor located on a 1999 2500 4 wheel drive Chevrolet Silverado?

It is bolted in the transfur case tail shaft housing.


What causes your Honda stream 2002 cam shaft censor to go bad?

It's Japanese. That's how.


Where is crank shaft position sensor located on 2002 Chevrolet 2500HD 6.0L Pickup?

It is on the left front side of timing cover behind the balancer.


Where is the throttle position sensor on a 1999 Chevrolet Cavalier located?

The throttle position sensor is mounted to the throttle body on the end of the throttle shaft opposite of the lever.


Where is the crank position sensor on a 1999 Chevrolet Malibu?

The 1999 Chevrolet Alamo crank shaft position sensor is located on the back of the engine. You will need to remove the rear engine cover in order to access the crank position sensor.


On a 1991 Chevrolet what would cause brake lights to remain on when car is switched off?

Check the brake switch located on your brake pedal shaft. May have to be replaced.


Where is abs speed sensor located on a 1994 Chevrolet K2500 suburban?

It is bolted in the transfur case tail shaft housing with 1 bolt and has an electric wire connected to it.