The camshaft sensor on a 1993 Pontiac Grand Am is located behind the rear bearing cap. It detects the position of the camshaft as it rotates and relays this information to the computer.
To install a camshaft position sensor on a 1996 Pontiac Grand Prix, first disconnect the negative battery cable to ensure safety. Locate the camshaft position sensor, typically found near the engine block, and remove any necessary engine covers. Disconnect the electrical connector and unscrew the sensor from its mounting position. Install the new sensor by reversing the steps: secure it in place, reconnect the electrical connector, and reattach any covers before reconnecting the battery.
On a 1998 Pontiac Grand Prix GTP, the camshaft position sensor is located on the front of the engine, typically near the timing cover. It is usually positioned close to the cylinder head, on the driver's side, and may be mounted on or near the camshaft gear. Accessing it may require removing other components for better visibility and reach.
The camshaft position sensor for the 3.0L V-6 engine is located in the distributor. Good Luck!
The Pontiac Grand Prix was produced from the years 1962 to 2008. The throttle position sensor in a 3.8 V6 Pontiac Grand Prix is located on the butterfly spindle of the throttle body.
Where is the throttle position sensor on a 1997 pontiac grand am 4 cyl.
there isn't a crankshaft position sensor on a 3.8l motor in a 1999 Pontiac grand prix according to the manual
On a 2007 Pontiac Grand Prix, the camshaft position sensor is typically located near the front of the engine, often on the cylinder head or engine block. Specifically, it can be found on the driver's side, near the timing cover. To access it, you may need to remove any engine covers or components that obstruct the sensor's visibility. Always consult the vehicle's service manual for precise instructions and diagrams.
How do i fix the TPS pedal position sensor in a grand prix pontiac 2004.
it is possible camshaft position sensor but i am not sure
It is under the front of the passenger side cylinder head.
Hi The CAMshaft position sensor on the v-8 4.7 liter engine is on the front right side (passenger) of the engine bank. The CRANKshaft sensor is behine the stater motor on the passenger side