the backof the fire wall center of the block about six inches above the oil pan
Yes! 1995-1999 yes it will fit but if you live in states that require inspections it will not pass because of the crank shaft sensor will not be picked up. been there done that!
Need to see diagram so i can remove or fix tail light on Chevrolet cavalier 1995
The 1995 for Crown Victoria camshaft position sensor can be found on the back of the cylinder head. The camshaft position sensor will be labeled as such.
The Camshaft sensor is located under the cap and rotor of the distributor. This is a common failure on the 2.4L engine due to oil leakage into the distributor. how is the camshaft sensor replaced on 1995 Nissan altima. what other considerations are there.
To test a 1995 Cavalier crank sensor you would need to get a mechanic's computer. They can put a sensor/fuse tester on it and see if it is working properly.
There is no cam sensor on the 1995 year engine. GM. did not use a cam sensor on that year.
For a Cavalier 2005-1995 driverside is 22" and the passenger 17"
1995-2005 Chevrolet Cavalier Replacement Wiper Blades:Driver side: 22"Passenger side: 17"
the oil pressure sending unit for a 1995 Cavalier 2.2 is on the side of the engine. The sensor is located just behind the oil filter.
The camshaft sensor is the same as the crankshaft sensor it is local on the passenger side of the valve cover . And going down to your crankshaft inside the timing belt cover
Inside the distributor
It is inside the distibutor.