The coolant sending unit on a Pontiac Aztek with a 3.4-liter engine is typically located on the engine block, near the thermostat housing. Specifically, it is often found on the driver's side, towards the rear of the engine, where it connects to the cooling system to monitor the engine's temperature. To access it, you may need to remove some components for better visibility and reach. Always refer to the vehicle's service manual for precise location and removal instructions.
The oil sending unit is located on the 1981 Pontiac Bonneville 265 engine is located on the Starter Disable Kit.
Coolant sending unit is located at the front of the left cylinder head
The 1997 Chevrolet Camaro 3.8 liter engine coolant temperature sending unit can be found on the front of the engine. The coolant temperature sending unit will be approximately 3 inches above the thermostat housing.
Coolant temperature sending unit is located on the front of the engine. The cooling temperature sending unit will be on the right hand side of the engine.
The coolant temperature sending unit on a 97 Mercury Sable is in the engine compartment. It is located on the intake manifold.
The 1999 Pontiac sun fire oil sending unit is located in the bottom of the engine. You will need to remove the oil pan in order to view the oil sending unit.
When my 1994 Pontiac Transport is in park and idling the the speedometer runs erratically? Why?
In answer to your question the coolant temperature sensor on a 2000 Pontiac grand am with a 3.4L engine, is located on the rear of the engine above the flywheel. It is located just behind the what I believe is the alternator.
Temperature Gauge Sending Unit The sending unit is located in the front section of the intake manifold in the vicinity of the thermostat.
where do i find the low side service port on a aztek
On a 2008 Pontiac Torrent with a 3.6L engine, the coolant temperature sensor is typically located near the thermostat housing, which is situated at the front of the engine. Specifically, it can usually be found on the engine block or intake manifold, close to the coolant outlet. For precise identification, it's advisable to refer to the vehicle's service manual or schematic diagrams.
Right above the oil filter on the oil filter housing.