Isn't one - that started in 1996
It is a six way OBD 1 connector under the dash on the driver side. The sixteen way OBD 2 connector did start in 1996
the alternator is right in the front behind the right side of the rad
The solenoid is attached to the starter. Replace the starter.
It does not have a cabin filter.It does not have a cabin filter.
under hood will say diagnostics on it should be driver side
The firing order should be 1-2-3-4-5-6.
Yes, since it was built with that when new.Yes, since it was built with that when new.
Nippondenso ER/IF 120 Amp, 12 Volt, CW, 6-Groove Pulley Used On (2001-98) Chrysler Concorde 2.7L(2001-98) Dodge Intrepid 2.7L Mitsubishi ER/IF 130 Amp, 12 Volt, CW, 6-Groove Pulley Used On (2001-99) Chrysler 300, LHS 3.5L(2001-98) Chrysler Concorde 3.2L(2001-98) Dodge Intrepid 3.2L(2001-00) Dodge Intrepid 3.5L Nippondenso ER/IF 90 Amp, 12 Volt, CW, 6-Groove Pulley Used On (1996-93) Chrysler Concorde 3.3L(1997-93) Chrysler Concorde, LHS 3.5L(1996-94) Chrysler New Yorker 3.5L(1997-93) Dodge Intrepid 3.3L, 3.5L(1997-93) Eagle Vision 3.3L, 3.5L(1997) Plymouth Prowler
i just connected my ac belt and there was a black wire that was disconnected from the battery and i attached it back to the battery
A 1993 Intrepid does not have a distributor cap.A 1993 Intrepid does not have a distributor cap.
No. The 93-97 LH cars equipped with the 3.5l V6 are not. However, 98 and up are interference.
Remove the radiator cover the connects to the frame. These are connected by 4 bolts.Unplug the radiator fan.Remove the top two clips that hold the radiator to the fan.Remove the bolts on the sides of the fan.An instructional video explaining how to remove a radiator fan from a 93-97 Dodge Intrepid has been included below.
where is the ac recharge port on a 93 ford explorer located?