answersLogoWhite

0

Most likely it is the TFI module mounted on the back side of the distributor. Takes a special tool to remove it, available at auto zone for about 5 bucks.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How do you change the ignition control module in a 1988 Chevy Silverado 5.7 L?

How do you change the ignition control module in a 1988 Chevy Silverado 5.7L


How do you remove the ignition module on a 1988 ford f-250?

how do you remove the ignition control module on a 1988 ford f-250 pickup?


Why won't a 1988 Bronco 302 spark after the coil distro cap rotor and ignition control module were changed?

OP here- Got it looked at and the entire distributor went out. Problem solved.


What is the Bolt size for ignition control module on a 1988 ford ranger?

4.5 mm but has to be deepwell


Where is the ignition module located on a 1989 Mazda b2200?

where is the ignition module located on a 1988 Mazda b2200


Where is 1988 bronco --4x4 solenoid control module located?

It is located on the transfer case this is the motor that shifts your four wheel drive


Where is ignition control module on 1988 dodge van 5.2 v8?

Behind the battery.Behind the battery.


What causes no spark in a 1988 Buick lasabre?

Crank sensor has failed,Ignition control module (ICM) has failed,Bad ignition coil pack,


Does ignition module have any control of fuel pump working?

Yes it does, from the year 1988 through early 1999 models.


Where is the ignition control module located in the 1988 Volvo 240?

Under Dash Passenger side to the right of the kick panel


Why might a 1988 Ford Bronco not start with a new battery gas plugs and a new ignition coil?

check your frame ground try the ignition module you need a special 5.5mm tool the part is only about 30 bucks


How do you set the timing on an 1988 Chevy Celebrity?

The 1988 Chevy Celebrity uses distributorless ignition. There is no provision to alter timing, the engine control module takes care of that.