it is under the driver panel where the wires are at there is a sticker there with 5 digit number
The Lincoln Navigator keypad entry code can be found in the back of the owners manual. You can only use the keypad entry code once and then you will have to enter your personal entry code.
Each vehicle that has keyless entry has its own code
usually on the trunk hinge
Somthing in denmark stinks..........
The keypad code is usually on a plastic card in the owners manual, or located near the top right hinge on the tail gate when open. It will be on a with adhesive tag. Normally 5 digits. Hope this helps
To reset the door keypad on a 2004 Lincoln Navigator, first, ensure the vehicle is in the "Off" position. Then, press and hold the "1" and "2" keys simultaneously until the keypad light flashes, indicating the system is ready to be programmed. Enter your desired five-digit code within five seconds, and the light will flash again to confirm the new code is accepted. Finally, test the new code by locking and unlocking the doors.
Lincoln should have the code in one of several places. There should be a credit card size sticker in the owners manual. There could be a sticker under the hood, or on a rear hatch strut. Or the code will be under the dash on the alarm control unit.
Every Lincoln sold has a different code. There is no one code that will work on all of them. If you have lost the code, then you will have to get the keypad reprogrammed. A Lincoln dealer is your only choice as far as I know.
711925
Pass.side kick panel.. remove the plastic door with a flash light..look at the control module (above the fuse box) that has the ford Number on it. It will be a five digit code in bigger numbers.
If you get on your back and look under the dash on the driver side you will see a computer module with a white sticker with the factory code on it. Enter that code and you will be able to reset it to your code. answer below is someone elses suggestionYou first have to get the Manufacturers code from a Ford dealer at a cost of about $40.00. Then you need to enter that code to reset the keypad , then you can enter your own code. hope this helps. Jack
Usually the keypad code is located in the trunk of your car right on the bars that hold your trunk open