On a 2000 Oldsmobile Intrigue, the map (Manifold Absolute Pressure) sensor is typically located on the intake manifold. It is mounted on the top or side of the manifold, near the throttle body. You may need to remove some components or covers for better access, depending on the specific engine configuration. Always consult the vehicle's service manual for precise location details and any necessary removal steps.
On the 99 Olds Intrigue, the camshaft sensor is located on the rear of the engine. It is just above the starter.
The camshaft sensor on the 99 Olds Intrigue is located on the engine block. It is under the starter, which has to be removed to locate the camshaft sensor.
Under the glove box.
On the air intake filter box
I have Olds Intrigue 2000 3.5L. Needed to replace faulty crankshaft sensor.3.5L engine has two of them. If engine is hard to start cold or hot and engine light is OK.Very common problem for this engine in Aurora 3.5 and Intrigue 3.5 is crankshaft position sensor. Which is located above and behind starter. Starter must be removed first.------------------------------------------------------------------------------------------------------------AnswerLower right hand side of the engine just above the oil pan. Theres a single bolt that holds it in.
there is none. the speed sensor is in the tranny
Took me about an hour to change mine, but it was the first time.
The ETC sensor on the 2002 Olds 3.5 engine is located at the right rear of engine, below the throttle body at the head not the block.
Had the same problem after looking all over finly went to the library. It behind the staster.
I have a 98 olds intrigue...the camshaft position sensor is located around the middle polley on the left side of the engine. It has one screw. It's fairly easy to install.
134a
$300 with labor