The outside temp sensor is located on the passenger side of grille by radiator
There are two sets of switchbanks located in the front of the vehicle. The switches will vary with the options that are on your vehicle.I don't know which one you refer to as bank 1 but the instrument panel switchbank is located in the instrument panel below the comfort controls. The overhead console switchbank is located in the overhead console.
I googled "04 Dodge Ram Manual" and downloaded the service manual from one of the links, which is different than the owners manual. The service manual is 2000+ pages long....here's what is says about the overhead console removal procedure....REMOVAL OVERHEAD CONSOLE REMOVAL (1) Disconnect and isolate the negative battery cable. (2) Remove the overhead console retaining screws, located in the sunglass storage bin. (3) Using your fingertips, grasp the sides of the overhead console and pull straight down evenly to disengage the two snap clips at the front of the unit. (4) Lower the overhead console far enough to access the wire harness connectors. (5) Disconnect the EVIC, CMTC electronic module and the reading/courtesy lamps electrical connectors. (6) Remove the overhead console from the vehicle. INSTALLATION (1) Position the overhead console in the vehicle. (2) Connect the EVIC, CMTC electronic module and the reading/courtesy lamps electrical connectors. (3) Grasp the sides of the overhead console and push straight up evenly to engage the two snap clips at the rear of the unit. (4) Install the overhead console retaining screw, located in the front of console. Torque the screw to 1.2 N·m (10 in. lbs.). (5) Connect the negative battery cable. I googled "04 Dodge Ram Manual" and downloaded the service manual from one of the links, which is different than the owners manual. The service manual is 2000+ pages long....here's what is says about the overhead console removal procedure....REMOVAL OVERHEAD CONSOLE REMOVAL (1) Disconnect and isolate the negative battery cable. (2) Remove the overhead console retaining screws, located in the sunglass storage bin. (3) Using your fingertips, grasp the sides of the overhead console and pull straight down evenly to disengage the two snap clips at the front of the unit. (4) Lower the overhead console far enough to access the wire harness connectors. (5) Disconnect the EVIC, CMTC electronic module and the reading/courtesy lamps electrical connectors. (6) Remove the overhead console from the vehicle. INSTALLATION (1) Position the overhead console in the vehicle. (2) Connect the EVIC, CMTC electronic module and the reading/courtesy lamps electrical connectors. (3) Grasp the sides of the overhead console and push straight up evenly to engage the two snap clips at the rear of the unit. (4) Install the overhead console retaining screw, located in the front of console. Torque the screw to 1.2 N·m (10 in. lbs.). (5) Connect the negative battery cable.
Under the console directly under radio and hvac controls
On a '86 corvette it is located behind the warning lite display/ mode switch unit in the upper part of the center console. (really stupid place for it.) there are 3 or 4 fuses located there including the one that controls the rear hatch release.
The temp sensor is located behind the bumper, below and to the left of the driver's side headlight.
#19
Generally on the dash above the radio, or if you have a overhead console it could be there!
In the Mercedes-Benz E320, the radio CD player is typically located in the center console of the dashboard. It is integrated into the vehicle's audio system, usually positioned above the climate controls. Depending on the specific model year, there may be a dedicated slot for CDs, and the controls are often accessible through a combination of buttons and a display screen.
look in your owner's manual i did not get one with the van
The ECM is located under the dash where the console meets the heating and air conditioning controls. Its on the tunnel housing in front of the console.
# Disconnect and isolate the remote negative battery cable. # Remove the overhead console retaining screw, located in the front of console near the windshield. # Using your fingertips, grasp the sides of the overhead console and pull straight down evenly to disengage the two snap clips at the rear of the unit. # Lower the overhead console far enough to access the wire harness connectors. # Disconnect the control module, courtesy lamps and if equipped, the power sunroof switch electrical connectors. # Remove the overhead console assembly from the vehicle.
The ECM is located inside your center console behind the controls.