in the exhaust system Very close to the manifold, you should see a wire come out of a large nut, to remove and replace you should have a socket made for this application
The Camshaft Position Sensor is located behind the Power Steering Pump.
A 1969 car would not have an oxygen sensor.
check main pulley area bottom by harmonic balance
the O2 Sensor Should be on top of your exhaust manifold
Plug has 3 wires.
The 1984 Cutlass is a model of car produced by the company Oldsmobile. The oxygen sensor is typically located near or on the engine block.
They are in the exhaust flow
On a 1994 Oldsmobile Achieva, the crankshaft position sensor is typically located near the crankshaft pulley, mounted on the engine block. It is positioned at the front of the engine, often near the transmission bell housing. To access it, you may need to remove some components, such as the air intake or other parts obstructing the sensor. Always consult the vehicle's service manual for specific details and diagrams.
The oxygen sensor on the 1999 Oldsmobile Cutlass Sierra is located on the lower exhaust. If you need to replace it, they are available for about $20 online.
your o2 sensors are located before and after your catallytic convertors
The map sensor is located next to the idler air control valve on the front of the motor on top. It has a vaccume hose hooked to it and one bolt holding it on with a bracket.
Where is the Knock Sensor located on a 1996 Oldsmobile Aurora?