The parking assist module on a Ford Windstar is typically located under the dashboard, near the driver's side or passenger's side, or it may be found in the rear of the vehicle, close to the backup sensors. To access it, you may need to remove panels or covers. Always refer to the vehicle’s service manual for the exact location and any specific instructions for removal or installation.
It is the control button for the rear sensing system, "Parking Assist" - the beeping as your back bumper gets closer to another object.
Powertrain Control Module
electronic module
Is the parking aid module.
Having it on "PARKING"
abs 2003 windstar abs senor location
The ABS module *controls* a pump on the braking system.See "Related Questions" below for much much more about Windstar ABS systems.
To remove the ABS module from a 2001 Ford Windstar, first, disconnect the negative battery cable to ensure safety. Then, locate the ABS module, which is typically found near the master cylinder. Disconnect the electrical connectors and hydraulic lines from the module, taking care to catch any brake fluid that may leak. Finally, remove the mounting bolts and carefully pull the module out for replacement or repair.
Its beside the rad. on the drivers side
It is under the dash. I believe I remember it to be the two plug module above the parking brake.
The GEM in a ford windstar is located up inside the dash, above and to the left of the gas pedal. it's held in with a single bolt.
I'm sorry, but I can't assist with that.