answersLogoWhite

0

the slave cylinder is bolted to the drivers side of the transmissions bellhousing,the reservoir for it is on tne drivers side firewall

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How do you connect the hydraulic to the clutch slave cylinder on a 2000 S10 chev pickup 2.2 4 cylinder?

how do you connect the hyraulic master cylinder to the clutch slave cylinder on a 2000 chevy S10 pickup 2.2 4.cylinder


Where is the slave cylinder at on a Chevy 1991 S10?

Inside bell housing. Transmission has to be removed to gain access to the slave cylinder/throw-out bearing.


Where is the slave cylinder located on a 2000 Chevy S10?

The slave cylinder is inside the trans. If you need to replace it you will have to pull the trans out. Its not that bad, its a afternoon though.


How do you change a clutch slave cylinder on a 1988 Chevy S10 Pickup?

You will need to remove the transmission to replace the clutch slave.


What are symptoms of timing belt slips on 2002 Chevrolet s10?

The 02 Chevy S10 with a 4 cylinder or a 6 cylinder does not have a timing belt.


How and where do you change a slave cylinder for a 1993 Chevy S10 manual pick up?

The slave cylinder on my s10 in on the driver side of the transmision. There are only 2 nuts that have to be removed to take the slave cylinder off. Then u must take out the pins to remove the clutch line.. Hope this helps


Why is clutch fluid leaking between transmission and motor on 1991 Chevy S10?

The clutch slave cylinder is probably at fault. Replacement is necessary to fix problem. Transmission must be removed to gain access to the slave cylinder.


Where is clutch slave cylinder on a 1999 Chevy s10?

It is inside of the transmission bell housing. You will have to remove the transmission to service it.


How do you change hydraulic clutch in 99 Chevy s10?

Which part do you want to replace? The slave cylider or the master cylinder? The hydraulic line and master cylinder.


How do you change a master cylinder for a 1998 Chevy S10?

How do you change a Master Cylinder and hydraulic clutch line for a 1998 Chevy S10?


Where is clutch slave cylinder on a 1994 Chevy s10?

It is mounted on the front side of the transmission, It will have a black plastic line coming from it and going up to the clutch master cylinder.


Why is clutch fluid reservoire losing fluid in Chevy 1997 s10?

Either the clutch master cylinder or the clutch slave cylinder or the clutch hydraulic lines are leaking.

Trending Questions
Why wont a 97 Plymouth breeze start after running it outr of gas even after you've put gas back in? Why does my 1984 Chevy pick up backfire after I give it gas? 97 Pontiac Bonneville has a rocker type lock out switch in the truck what is it for? How much money is it to fill a 2010 for f150? Why would clutches in all wheel drive 2000 Merc Mountaineer make noise and vibrate slip when starting out in a turn once vehicle has warmed up after fluid changed in transfer cases and rear? Why is your 2002 Cadillac DeVille making a whining sound? Why would the speedometer quit working in a 2002 Dodge Ram 1500 truck? Where are the horns on a 1997 Crown Victoria? What is the towing capacity of the 2006 Ford freestyle? How much gear oil does a 10 bolt rear end hold on a 1990 silverado half ton pickup with a v8 and 4wd? Where is the fuel cut off switch in a Chevrolet Suburban? Where are the spark plugs on an 1998 Oldsmobile 88? What would make 1993 s10 blaze smoke? How do you get check engine light off long enough to pass the emissions on 1999 kia sportage? Where is the inertia fuel shutoff switch on 1991 ford mustang? What rear end in 2014 ss Camaro? Why would a 1996 Chevy Tahoe steering shake at 40 mph and stop shaking around 60 mph? You broke the key off in the ignition of your 1991 ford aerostar how do you remove the egnition to get the key end out or what is the best way to remove the key end? What kind of oil do refill the transfercase on a 2000 Oldsmobile bravada? What color is an R12 port on a 1995 jeep grand Cherokee?