It is at the lower end of the top radiator hose within the water outlet on the motor.
The sensor is threaded into the head to the left of the thermostat housing and has a single wire connector on it. Thanks Malcolm
To replace the thermostat in a Mazda 323, first ensure the engine is cool, then drain the coolant from the radiator. Remove the thermostat housing by unscrewing the bolts and disconnecting the hose. Take out the old thermostat, clean the mating surfaces, and install the new thermostat with the correct orientation. Reassemble the housing, reconnect the hose, refill the coolant, and check for leaks.
Look at the engine end of the upper radiator hose in a removable housing
unbolt tranny from engine clutch is between them
can you tell me where the my 03 plate Mazda 323 2 litre diesels speed sensor is located as its not working .ta
Hitachi 2V is listed for the 323 1.5Ltr E5 engine (1981-1985).
The speedometer cable on a 1987 Mazda 323 is located on top of the transmission and travels up to the dashboard. It helps the vehicle's computer monitor speeds constantly.
The Mazda 323 fuel filter is located in the fuel tank. The fuel tank will need to be drained in order to change the fuel filter.
Where can I find the fuel pump relay on a 2000 mazda 323
== == It's located within the thermostat housing, to the right side of the engine... follow the large rubber tube coming from the radiator and it shall lead you to the housing, which is held in place by two bolts. Warning: if you take the housing off, to replace the thermostat, be gentle with the thermoswitch, and it is also very fiddly to have the thermostat centralised on the housing when you bolt it back on.
The flasher unit on a Mazda 323 is located on the end of the flasher lever. Remove the lower steering column to bring the unit to view.
it is to the left of the engine beside your belt.